5
Connecting the WS antenna
For safety reasons, make sure that the unit is not
plugged in and batteries are not installed when
making connections.
To install the WS antenna
1.
To install the WS antenna, orient the antenna by
lining up the arrow marks on the front of the WS
antenna and on the front side of the housing
platform. Slide the antenna into the housing
platform at an angle so that the groove on the
back side of the base of the antenna fits into the
corresponding tab on this unit.
2.
Push down on the front end of the base of the
antenna until it clicks into place.
To connect the antenna cable
Connect the antenna cable to the antenna jack
located on the rear panel of the unit.
Notes:
• Be sure not to place the back of this unit against a wall or
other surface when the antenna cable is connected as it
may damage the cable and/or antenna jack.
• Be sure to check that the cable under and not over the
handle of the unit. If the cable is over the handle, using
the handle to carry this unit may be the cause of
malfunction.
To remove the WS antenna from the
housing platform
Pull up on the front end of the antenna unit to unlock
the base. The WS antenna should then be easily
removable.
CAUTION:
DO NOT FORCE THE WS ANTENNA INTO OR OUT
OF THE HOUSING PLATFORM. THIS MAY CAUSE
DAMAGE TO THE WS ANTENNA AND CAUSE THIS
UNIT TO PERFORM IMPROPERLY.
To connect the extension cable.
1.
Disconnect the WS antenna from the antenna
jack.
2.
Connect the extension cable into the antenna jack
on the rear panel of the unit.
3.
Slide the rain protection cover on the extension
cable back so that the connector protrudes.
4.
Firmly connect the extension cable with the WS
antenna cable.
5.
Slide the rain protection cover over the
connected section completely for best
performance.
CAUTION:
The rain protection cover is not intended to be left
out in heavy rain or submerged in water. Please
avoid exposing this section of the cable to excessive
moisture.
Notes:
• To help ensure long-lasting performance of this unit, do
not leave the extension cable and antenna outside or in
direct sunlight for long periods of time. It is
recommended that you restore the WS antenna to the
housing platform when you are finished using the unit.
• The WS specified extension cable supplied with this unit
is specially designed for use with this unit. Should you
use a cable not supplied with this unit nor recommended
by JVC for use with this unit, JVC cannot guarantee the
performance of this unit. For details regarding
compatibility with this unit, please consult with the
manufacturer of the cable.
To adjust the WS antenna
For details on how to position the WS antenna for
best possible reception, refer to page 9.
ACE ANTENNA SYSTEM
WS
LEARN
PTY
MULTI/LANG
PASSWORD
TUNING / SELECT
BAND
MEMORY
/ CANCEL
VOLUME
SOUND
AUTO PRESET
ON /
STANDBY
PRESET
ANTENNA
WARNING
• DO NOT PUT BATTERY IN BACKWARDS, MIX WITH
USED OR OTHER BATTERY TYPES-MAY EXPLODE
OR LEAK AND CAUSE PERSONAL INJURY.
• REMOVE THE BATTERIES ("D" SIZE, R20) WHEN
USING THE AC POWER.
• SEE INSTRUCTION MANUAL.
EXTERNAL
LITE ANTENNA SYSTEM
WS
LEARN
PTY
MULTI/LANG
PASSWORD
TUNING / SELECT
BAND
MEMORY
/ CANCEL
VOLUME
SOUND
AUTO PRESET
ON /
STANDBY
PRESET
PACE ANTENNA SYSTEM
WS
LEARN
PTY
MULTI/LANG
PASSWORD
TUNING / SELECT
BAND
MEMORY
/ CANCEL
VOLUME
SOUND
AUTO PRESET
ON /
STANDBY
PRESET
\
FR-DS100.02-08
5/5/99, 12:46 PM
5
