(No.MA101)1-23
3.4
DVD mechanism assembly section
3.4.1 Removing the front end board
(See Fig.1)
Caution:
Before disconnecting the flexible wire extending from the DVD
pickup, solder the short-circuit point on the flexible wire using
a grounding soldering iron.
If you do not follow this instruction, the DVD pickup may be
damaged.
(1) Turn over the body, and solder the short-circuit points on
the flexible wire extending from the DVD pickup.
(2) Disconnect the flexible wire from connector
CN101
on the
front end board.
(3) Disconnect the card wire from connector
CN201
on the
front end board.
(4) Disconnect the flexible wire from connector
CN202
on the
front end board.
(5) Unsolder two soldered points
a
on the front end board and
remove the wire extending from the feed motor.
(6) Remove the two screws
A
and screw
B
attaching the front
end board.
Caution:
• As the flexible wire to be connected to
CN101
, make sure to
attach it to the front end board using a double tape.
• After reassembling, unsolder the short-circuit points.
Fig.1
Double tape
Feed motor
Front end board
CN202
CN101
A
a
B
A
CN201
Flexible wire
Short-circuit points
Card wire
DVD mechanism assembly
Содержание EXAD KD-AV7000
Страница 17: ... No MA101 1 17 Fig 9 Fig 10 Fig 11 Motor bracket S E Worm gear 16 0 1 mm Motor Double worm Display drive unit ...
Страница 59: ... No MA101 1 59 ...
Страница 106: ...3 46 MEMO ...