EN
67
DETAILS
I T E M S
N O T E S
❍
Perform charging where the temperature is between 10°C and 35°C (50°F
and 95°F). 20°C to 25°C (68°F to 77°F) is the ideal temperature range for
charging. If the environment is too cold, charging may be incomplete.
❍
Charging times are for a fully discharged battery pack.
❍
Charging time varies according to the ambient temperature and the status of
the battery pack.
❍
To avoid interference with reception, do not use the AC Adapter near a radio.
❍
Since the AC Adapter processes electricity internally, it becomes warm
during use. Be sure to use it only in well-ventilated areas.
❍
The following operation stops charging:
• Set the Power Switch to “PLAY”, “
AUTO
” or “
MANUAL
”.
• Disconnect the AC adapter from the camcorder.
• Unplug the AC adapter from the AC outlet.
• Detach the battery from the camcorder.
❍
When you use the LCD monitor outdoors in direct sunlight, the LCD monitor
may be difficult to see. If this happens, use the viewfinder instead.
❍
The cassette holder cannot be opened unless a power supply is attached.
❍
There may be a delay after you open the cassette holder cover until the
cassette holder opens. Do not use force.
❍
Once the cassette holder is closed, it recedes automatically. Wait until it
recedes completely before closing the cassette holder cover.
❍
When the Recording Start/Stop button is pressed, it may take a few seconds
before actual recording starts. “
” starts rotating when the camcorder
actually starts recording.
❍
The time required to calculate and display the remaining tape length, and the
accuracy of the calculation, may vary according to the type of tape used.
❍
“TAPE END” appears when the tape reaches its end, and the power goes off
automatically if left in this condition for 5 minutes. “TAPE END” also appears
when a cassette at its end is loaded.
➪
TAPE
RECORDING
(
墌
pg. 16, 17)
➪
Power
(
墌
pg. 8)