3-4(No.YD046)
DVD mechanism assembly and parts list
b
c
31
31
30
16
3
21
2
17
8
15
17
8
4
8
5
8
17
6
12
13
14
11
9
7
NOTES:
CLAMPER SA
1.Attach the MAGNET to the CLAMPER.
2.Lock the MAGNET and BACK YORK to the CLAMPER firmly
with its 3 hooks.
3.Make sure that none of the 3 hooks of the CLAMPER is
broken/ bent/ changed in shape.
3 hooks
21
20
LOWER CASE
[FIG-1] LOADING MOTOR - PULLEY Press Fitting.
MOTOR PULLEY Height should be
5.35
-0.1
-0.4
5.35
-0.4
-0.1
(Measurement between the top part of the PULLEY
and the top of the MOTOR Can)
[FIG-2] INSULATOR Attachment
DRAWING FROM
DIRECTION A
DRAWING FROM
DIRECTION B
[FIG-3] GEAR Attachment
Each Phase Adjustment Mark
is on the straight line.
[FIG-3] LOWER CASE/ SLIDER Grease Application Point
SLIDER: 6 Grease Application Points
Type of Grease: TAG- 200R
Amount of Grease: 8 1mg each
NOTES:
1.After the attachment of the SLIDER to the LOWER CASE, pull
the SLIDER towards the SNAPFIT (left side). Apply the grease
to the points shown in the figure below.
2.Grease should be applied before the attachment of
TRAVERSE BASE SA.
LOWER CASE
SLIDER Grease Application Points
LOWER CASE: 9 Grease Application Points
Type of Grease: TAG- 200R
Amount of Grease: 8 1mg each
NOTES:
3.Apply Grease in the center of GEAR Attaching SHAFT.
4.Apply Grease before attaching any kind of GEARS.
LOWER CASE
LOADER SCREW
INSULATOR
LOADER BKT
1.Insert the INSULATOR firmly without mixing
up the top and bottom side.
2.After the attachment of the INSULATOR,
fasten the LOADER SCREW.
NOTES:
3.Be sure that the LOADER SCREW is not
fastened at an angle of improperly fastened.
NOTES:
1.Attachment order of the GEARS is as follows,
[GEAR 2] [GEAR 3] [GEAR 1] [PULLEY GEAR].
Be sure to adjust the Phase of GEAR 2 and GEAR 3.
NOTES:
Make mark as a Phase
Adjustment Mark
<GEAR 2 Phase Mark>
<GEAR 3 Phase Mark>
Make the salient of the outer circumference
of GEAR 3 as a Phase Adjustment Mark.
Correct Phase Adjustment
"a"
Note: Application amount at area "a"
(left of PULLEY GEAR SHAFT) is 64 4mg.
1
9
10
TOP COVER Back
24
23
22
3
21
3
1
10
CLAMPER SA
Back
29
28
27
26
26
25
19
19
18
6
5
B l o c k N o . M 2 M M
We cannot supply parts that are not
in the Parts List, as they are not
exchangeable because of the
design feature. Please handle the
replacement with Mechanism
Assembly Units.
