– 9 –
English
Common Operations
Setting the Clock
Before operating the unit any further, first set the clock built
in this unit.
• As you plug in the AC power cord, the clock starts counting
from “0:00.”
On the remote control ONLY:
1
Press and hold SHIFT during the
setting procedure.
2
Press CLOCK.
The “CLOCK” indicator on the display lights
up and the clock time start flashing.
3
Press SELECT – or + to set the
time.
Pressing increases the time and
pressing SELECT – decreases the time.
Pressing the button continuously advances
or postpones the time in 10 minute intervals.
4
Press SET.
The time display stops flashing.
5
Release SHIFT.
If there is a power failure
The clock loses the setting and is reset to “0:00.” You need to set the
clock again.
Turning On the Power and Selecting the
Sources
When you press the play button for a particular source (FM/
AM, CD
6
, TAPE
2
3
, and AUX), the unit turns on.
The unit starts playing the source if it is ready — COMPU
PLAY CONTROL.
To listen to the FM/AM broadcasts, press FM/AM. (See
page 11.)
To play back CDs, press CD
6
. (See pages 12 – 18.)
To play back tapes, press TAPE
2
3
. (See pages 19 – 20.)
To select the external equipment as the source, press AUX.
To turn on the unit without playing, press
(standby/on) so that the STANDBY lamp goes
off.
To turn off the unit (on standby), press
(standby/on) again so that the STANDBY lamp
lights up.
A little power is always consumed even while the
unit is on standby.
To switch off the power supply completely, unplug the AC
power cord from the AC outlet.
When you unplug the AC power cord or if a power
failure occurs
The clock is reset to “0:00” right away, while the tuner preset
stations (see page 11) will be erased in a few days.
CLOCK
CLOCK
SHIFT
CLOCK
1
SELECT
–
+
4
5
SET
8
FM /AM
TAPE
AUX
STANDBY
STANDBY
SHIFT
C D
SELECT
MX-J270V[US,UX]01-11 EN/f
00.7.21, 11:32 AM
9
