(No.MB399)1-21
3.2.5 Removing the pickup
(See Figs.4,6 to 8)
• Remove the traverse mechanism assembly.
(1) From the side of the traverse mechanism assembly, solder
the short land sections
d
on the pickup. (See Fig.4.)
(2) Release the lock of the connector on the pickup in the di-
rection of the arrow and disconnect the card wire. (See
Fig.6.)
Caution:
• Solder the short land sections
d
on the pickup before
disconnecting the card wire from the connector on the
pickup. If the card wire is disconnected without attach-
ing solder, the pickup may be destroyed by static elec-
tricity. (See Figs.4 and 6.)
• When attaching the pickup, be sure to remove solders
from the short land sections
d
after connecting the
card wire to the connector on the pickup. (See Figs.4
and 6.)
(3) Remove the screw
E
attaching the plate and thrust spring.
(See Fig.6.)
(4) Remove the engagement section
h
attaching the plate to
the feed holder and remove the plate. (See Fig.6.)
(5) Remove the engagement sections (
i
,
j
), remove the thrust
spring. (See Fig.6.)
(6) Remove the shaft of the pickup from the section
k
on the
traverse mechanism assembly and remove the shaft from
the section
m
while moving it in the direction of the arrow.
(See Fig.7.)
(7) Remove the pickup from the section
n
of the traverse
mechanism assembly and take out the pickup with the
shaft. (See fig.7.)
(8) From the bottom side of the pickup, remove the two screws
F
attaching the SW actuator and lead spring. (See Fig.8.)
(9) Pull the shaft out of the pickup. (See Fig.8.)
Fig.6
Fig.7
Pickup
Connector
Card wire
Thrust spring
Plate
E
h
Traverse mechanism assembly
Feed holder
i
j
Thrust spring
Shaft
Pickup
Traverse mechanism assembly
k
m
n
Torsion spring
