JVC 330, Руководство по обслуживанию

Страница: 35 / 163

Chapter 2—Functional Description
Model 330, 340SC and 370SC Service Manual 2-23
I T Blank Commanded position of top blanking.
I B Blank Commanded position of bottom blanking.
I
/STBP Command for DC restore timing on either
leading or trailing edge of sync pulse.
I
DC Restore Delay Commanded timing of DC restore after
reference edge of sync pulse.
I
Internal Sync Forced Command to force internal sync select.
I
Correction Start Delay Commanded H phase of correction map.
I Pincushion Start Delay Commanded H phase of pincushion, keystone,
and linearity correction.
I
2H Sync Enable Command determines path of H sync signal.
I Shifted Sync Enable Command determines path of H sync signal.
O /External Sync Detect Is an external sync available.
O HCount Count of H lines per frame.
O
/Phase Lock Indication of PLL lock.
O Phase Count Indication of phase difference between
HSYNC and HFlyback.
Raster Timing Generator I/O
This section provides a description of the inputs to and outputs from the RTG. The I/O
description are arranged by the source/destination of the signal and so the assemblies
communicated with are used as the primary heading of each group of signals and then are
further subdivided into inputs and outputs. In each case, the signal's direction is noted,
with input referring to an input to the RTG, and output to an output from the RTG. (e.g.:
under System Controller Board “Input”; SYSCLK refers to the signal SYSCLK that is an
input to the RTG from the System Controller Board). When test points are provided for
the I/O they are noted.
Table 2-5 Raster Timing Generator I/O Signals
System Controller Board
Inputs Description
SYSCLK 4 MHz clock signal for derivation of internal HDTV sync signal.
(TP 13)
IICCLK IIC clock line. Unidirectional clock line for control of
synchronous data transfer over IIC data bus.
Outputs Description
/IICINT IIC interrupt line. Signal line for slave boards to inform the SCB
(master) that there is data to be transferred. Master then polls
slaves to determine the source of the interrupt.
/Hx224 Square wave signal 224 X the horizontal frequency for overlay
address generator clocking. (TP 23)