length of 50cm (BS3212 and EN1763-1). Choose the proper regulator according to outlet pressure in the
technical table in page 14.
You will need to purchase suitable gas hose and regulator from your local gas dealer if the appliance does not
include gas hose and regulator.
●
Never use a gas cylinder with a damaged body, valve, collar, or foot ring. A dented or rusty gas tank may be
hazardous and should be checked out by a gas supplier.
●
Never connect this appliance to an unregulated gas source.
●
When the appliance is not in use, turn the gas cylinder OFF.
●
Always perform a leak test on gas connections whenever a cylinder is connected. If bubbles form in the leak
test solution, do not use. Never use a flame to test for leaks.
CONNECTING TO A GAS CYLINDER
●
Recommended to use max.15kg or smaller gas cylinder (maximum height 65cm) refer to your gas supplier for
suitable gas cylinder.
●
Approved gas regulator is used according to appliances categories and countries listed in data plate. Approved
flexible hose would be changed when the national conditions require it.
●
Assembly of the tubing must be conducted by some qualified tuber of destination countries.
●
Only change gas cylinders outdoors or in a well ventilated area away from naked flames and any other source
of ignition (candle, cigarettes, other flame producing appliance….).
●
The gas cylinder must always be used in an upright position.
●
Close the heater control knob by turning fully clockwise.
●
Close the gas cylinder tap and then attach the regulator onto the gas cylinder.
●
Tighten all connections firmly and with a spanner where appropriate. The cylinder should be located on the
cylinder base.
●
Check for leaks at all joints using soapy water. If a leak is found, tighten the joint and then re-test.
OPERATING INSTRUCTIONS
BEFORE FIRST USE AND AFTER EVERY GAS CYLINDER CHANGE, GAS DELIVERY SYSTEM MUST BE
PURGED OF AIR BEFORE IGNITING! TO DO THIS, TURN THE CONTROL KNOB ANTI-CLOCKWISE TO THE
PILOT SETTING. PRESS KNOB IN AND HOLD FOR 3 MINUTES BEFORE ATTEMPTING IGNITION.
BATTERY REPLACMENT
Remove impulse ignition cap from Burner Assembly (J) by turning cap counterclockwise. Install 1 AAA battery.
Negative end of battery goes in first, then replace impulse ignition cap by turning cap clockwise.
TO LIGHT THE PILOT
●
Check all connections prior to each use.
●
Turn on main gas supply at source.
●
Press to turn control knob anti-clockwise to
PILOT
, see right photo.
●
Hold knob depressed, press
IGNITION
button repeatedly until pilot
flame is lit, then continue to hold the knob depressed for 10 seconds
until the pilot remains it after releasing knob.
●
If pilot fails to ignite or alight, press to turn knob clockwise to
OFF
and repeat.
!
10
