TO LIGHT THE PATIO HEATER
●
The pilot should be lit and the knob set to
PILOT
.
●
Hold knob depressed gently and turn anti-clockwise to
LOW
.
●
When mesh glows lit, turn knob clockwise from
Low
to
HIGH
as needed.
Note: The burner may be noisy when initially turned on. To eliminate excessive noise from the burner, turn
the control knob to the pilot position. Then turn the knob to the level of heat desired.
RE-LIGHTING
●
Turn Control Knob to OFF.
●
Wait at least 5 minutes, to let gas dissipate, before attempting to re-light pilot.
●
Repeat the “Lighting” steps.
TO EXTINGUISH
●
Hold knob depressed & turn the knob clockwise to 'OFF'
●
Close the valve of the gas cylinder or the regulator after use.
●
Close the gas bottle and allow this appliance to cool before moving the appliance.
Note: After use, some discoloration of the emitter screen is normal. Close regulator after use, allow the
appliance to cool before moving.
IMPORTANT SAFETY RULES
For use outdoors or in amply ventilated areas.
An amply ventilated area must have a minimum of 25% of the surface area open.
The surface area is the sum of the walls surface.
The use of this appliance in enclosed areas can be dangerous and is PROHIBITED.
Children and adults should be aware of the high operating temperatures of areas above the
post when operating this heater.
Children should be carefully supervised when in the vicinity of the heater.
NEVER
hang anything, including clothes or any other flammable items, on this heater.
DO NOT
operate this heater unless it is fully assembled with its reflector in place.
Respect the minimum clearances from combustible materials.
MAINTENANCE
To enjoy years of outstanding performance from your heater, make sure you perform the following maintenance
activities on a regular basis:
●
Keep exterior surfaces clean.
●
Use warm soapy water for cleaning. Never use flammable or corrosive cleaning agents.
●
While washing your unit, be sure to keep the area around the burner and pilot assembly dry at all times. If the
gas control is exposed to water in any way,
DO NOT
try to use it. It must be replaced.
●
Airflow must be unobstructed. Keep controls, burner and circulation air passageways clean. Signs of possible
blockage include:
■
Gas odor with extreme yellow tipping of flame.
■
Heater does
NOT
reach the desired temperature.
■
Heater glow is excessively uneven.
!
11
