11
LARGE CUP MILD
Press symbol
.
LARGE CUP MILD Your product is being prepared.
PLEASE SELECT
8.3 Drawing off pre-ground coffee
Never use instant coffee or quick-coffee. We recommend
that you always use powder from fresh coffee beans or, pre-
ground, vacuum-packed coffee. Never fill in more than 2
portions of powder. The pre-ground coffee tank is no storage
tank. Make sure that the pre-ground you use is not too fine.
This may cause blocking of the system. In this case the
coffee only drips out of the coffee spout.
If you press the draw-off key unintentionally, you can stop
the operation by pressing the maintenance key. Your coffee
machine will carry out a rinsing operation.
Use the key
to switch on the coffee machine.
WWW. IMPRESSA-F-LINE.COM
HELLO, MACHINE HEATING UP
PRESS MAINTENANCE
MACHINE RINSING
PLEASE SELECT
Press selection key
.
FILL IN POWDER / PLEASE SELECT
Now fill in 1 or 2 level dosing spoonfuls of pre-ground coffee in
the filler funnel for pre-ground coffee (Fig. 5).
Place 1 cup under the adjustable coffee spout (16) and press the
corresponding symbol (
/
/ ).
LARGE CUP POWDER
Press symbol
.
LARGE CUP POWDER Your powder coffee is
being prepared.
Display:
PLEASE SELECT
9. Drawing off hot water
You can adjust the water portion individually (see Chapter
12 Programming). Install the hot water nozzle (Fig. 7) to
obtain perfect water flow.
At the start of the water draw-off there can be splashing
Avoid direct contact with the skin!
Do not replace the hot water nozzle directly after drawing off
water, because the nozzle is hot after the draw-off operation.
Place a cup under the hot water nozzle (15).
Press water draw-off key .
WATER PORTION
The programmed portion is being prepared. You can stop the
draw-off operation at any time by pressing the draw-off key .
PLEASE SELECT
10. Drawing off steam
Steam can be used for heating liquids and frothing milk for
cappuccino. Make sure that the steam/frothing nozzle (14) is
pushed upwards when liquids are heated. Push down the
frothing aid (Fig. 7) to froth liquids.
If you do not draw off steam within 3 minutes, steam draw-
off mode is terminated.
Install the steam/frothing nozzle (Fig. 7). This is included in
your Welcome Pack.
E
