JA95-N70 Audio Controller with RX Volume Controls - NVG
Installation and Operating Manual
Rev
C
Page 22
3.3.7
Multi-Function (XMIT / ICS) Switch Operation
Note
: At installation, this switch may be configured to operate in default or alternative mode. Check with
your installing agency for confirmation of the operation of this switch.
Default Operation
When in the default XMIT/ICS configuration, this switch acts as the pilot’s ‘Press-to-talk (PTT) button. The unit will
transmit on the selected transceiver when the switch is set to the ‘up’ position, and when set to the ‘down’ position, it
will transmit on the intercom.
Alternative Operation
This switch may be configured to provide a ground signal to operate other equipment.
3.3.8
RX Mute Operation
An external RX Mute switch may be installed in the aircraft. Check with your installing agency for confirmation of the
operation of this switch if installed. When activated, the external RX mute switch will silence all COM and NAV
receivers except for the receiver of the radio selected by the COM TX select knob.
The PHN HI / LO outputs consist of the sum of the selected COM and NAV Receive audio inputs when not
transmitting. If transmitting, and muting of receive audio during transmit is enabled or when the RX MUTE input is
active, these outputs will be muted.
3.4
Emergency Operation Mode
Emergency mode can be selected by the Mode switch on the front panel, or entered automatically if power to the unit
is lost.
3.4.1
Auto Emergency Mode
If the unit is in emergency mode because power has been lost to the unit, the sum of the COM1 transceiver, NAV1
receive, and DIRECT AUDIO will be routed to the pilot’s phones and the CVR. The pilot's microphone and transmit
key are connected to the COM1 transceiver. No other function in the JA95-N70 will operate when power is lost. All
indicator LEDs, legends and annunciators will be dark.
3.4.2
Selected Emergency Mode
If the unit is in emergency mode because the EMER / NORM switch is in the EMER position and sufficient power is
applied to the JA95-N70, the sum of the COM1 receive, NAV1 receive, DIRECT AUDIO and Alert audio will be
routed to the pilot’s phones and the CVR. The pilot's microphone and transmit key are connected to the COM1
transceiver. The pilot is disconnected from the ICS. The COM1 transceiver and NAV1 receiver and DIRECT AUDIO
are not available to the other users. All other functions of the JA95-N70 will operate. The LEDs, legends and
annunciators will retain normal functionality.