If the function Descaling is not
performed in the correct way,
the display will show a
message to repeat it.
If the appliance is humid and wet, wipe it
out with a dry cloth. Let the appliance dry
fully with the door open.
Descaling reminder
There are two descaling reminders which
remind you to perform the function:
Descaling. These reminders activate each
time you switch off the appliance. When
reminder is active S3 flashes in the
display.
• The soft reminder reminds and
recommends you to perform the
descaling cycle.
• The hard reminder obligates you to
perform the descaling. If you do not
descale the appliance when the hard
reminder is on, you cannot use the
steam functions. You cannot disable
the descaling reminder.
Steam generation system -
Rinsing - S4
Remove all accessories.
The duration of the function is around 30
minutes.
The light in this function is off.
1. Put the tray on the first shelf position.
2. Fill the water drawer with fresh water
to the maximum level until the acoustic
signal sounds or the display shows the
message.
3. Activate Rinsing function - S4. Refer to
"Activating a cleaning function".
Remove the tray after the end of the
procedure.
Removing and installing the
door
You can remove the door and the internal
glass panels to clean it. The number of
glass panels is different for different
models.
WARNING! The door is heavy.
1. Open the door fully.
2. Fully lift up the clamping levers (A) on
the two door hinges.
A
A
3. Close the door until it is at an angle of
approximately 45°.
45°
4. Hold the door with one hand on each
side and pull it away from the oven at
an upwards angle.
5. Put the door with the outer side down
on a soft cloth on a stable surface.
6. Hold the door trim (B) on the top edge
of the door at the two sides and push
inwards to release the clip seal.
1
2
B
49
Содержание 944182408
Страница 1: ...JBD167D0 JBD167D2 User Manual EN Steam oven...
Страница 55: ......
Страница 56: ...867353479 B 262021...