Juniper MEDIA FLOW CONTROLLER 2.0.4 -, Руководство администратора

Страница: 64 / 400

Media Flow Controller Configuration Tasks (CLI) Media Flow Controller Administrator’s Guide
64 Configuring Media Flow Controller System Clock and Banners (CLI) Copyright © 2010, Juniper Networks, Inc.
Figure 5 Example Connectivity
Note! Eth0 and Eth, typically the first two interfaces you use, are usually the first two network
ports built into the system—either part of the system board, or the first add-in card or module.
Note! Lights Out management (also known as "out-of-band") involves the use of a dedicated
management channel for device maintenance. It allows you to monitor and manage servers
and other network equipment by remote control regardless of whether the machine is powered
on. You can configure out-of-band management through the BIOS.
Important! Media Flow Controller does not support RAID arrays.
Configuring Media Flow Controller System Clock and Banners (CLI)
Before you configure Media Flow Controller system clock and banners, see “Before You
Configure Media Flow Controller” on page 58 . Proper time configuration is required for
accurate functioning. To configure an NTP (network time protocol) server OR system clock
and timezone:
1. Configure NTP server. Use show ntp to verify.
ntp server 123.45.10.8
Example:
test-vos (config) # ntp server 123.45.10.7
Alternately, configure the system clock, and timezone. Use show clock to verify.
clock set <hh:mm:ss> [<yyyy/mm/dd>]
clock timezone <zone> [<zone_word>] [<zone_word>] ...
Example:
test-vos (config) # clock set 15:51:30
Switch
User
User User
Internet
g015428
Origin
Server
Terminal server console
Switch
Intranet/
Internet
Origin
Server
Management station
Management VLAN
Media Flow Controller
traffic
Eth 2, 3, 4...
HTTP (80)
origin fetch
Eth 1
HTTP (80)
management
Eth0
HTTP (8080)
SSH (22)
HTTP
NFS