Juniper MEDIA FLOW CONTROLLER 2.0.4 -, Руководство администратора

Страница: 121 / 400

Configuring Interfaces, Default Gateway, Static Routes, DNS and Domain Names, Hostname and Banners (Web
Media Flow Controller Administrator’s Guide Media Flow Controller Configuration Tasks (Web Interface)
• Specify IP Address Manually—Enter the IP address and Netmask you want for this
Media Flow Controller.
• Speed and Duplex—Choose Auto (default) for the Speed and Duplex to be set
automatically based on hardware. Or you can set these options to alternate values in
the drop-down menu.
Note! We highly recommend that Speed and Duplex not be
changed from the auto-configured defaults.
• MTU—The Maximum Transmission Unit (MTU) sets the largest number of bytes a
frame can carry. Default is 1500.
• Comment—A description for the interface.
2. Click Apply to immediately apply changes; Cancel to revert to the existing configuration.
3. Click Save at the top of the page to make changes persistent.
Additional interface state areas are displayed for each interface discovered by the system. To
configure additional interfaces, click Configure Interface in the state area for each to open a
configuration area identical to the eth0 configuration area.
DHCP Primary Interface
Set DHCP (dynamic host configuration protocol) primary interface and verify the current
primary DHCP interface. See
Figure 13 for a graphic.
Figure 13 Network Interfaces Page Detail (DHCP Primary Interface)
DHCP allows new network devices to be automatically supplied with an IP address and other
information, depending on the setup of the DHCP server. Media Flow Controller has no
primary DHCP interface by default. Setting a primary interface ensures that DHCP messages
arrive only on that interface.
To set the DHCP Primary interface:
1. Choose a Configured primary interface from the drop-down list.
2. Click Apply to immediately apply changes; Cancel to revert to existing configuration.
3. Click Save at the top of the page to make changes persistent.