> Node display name is "node1"
> Password for Junos Space maintenance mode is set.
A> Apply settings
C> Change settings
Q> Quit and set up later
R> Redraw Menu
Choice [ACQR]:
•
To configure the appliance as a primary or standalone FMPM node, do the following:
NOTE:
You can also configure an appliance as a secondary or backup
FMPM node. For details, refer to the Configuring a Junos Space Appliance
as a Backup or Secondary FMPM Node for High Availability topic in the
JA2500 Junos Space Appliance Hardware Guide.
a.
Type
F
to proceed with the configuration of the appliance as an FMPM node.
b.
Configure the Ethernet interface eth0.
NOTE:
If you are configuring the appliance as part of a cluster (fabric),
then all nodes in that fabric must be in the same subnet.
•
To configure the IPv4 address for the eth0 interface:
i.
Type
1
.
ii.
Type the IPv4 address for eth0 interface in dotted-decimal notation and
press Enter.
iii.
Type the subnet mask for the IPv4 address and press Enter.
iv.
Type the IPv4 address of the default gateway in dotted-decimal notation
and press Enter.
•
(Optional) To configure both IPv4 and IPv6 address for the eth0 interface:
i.
Type
2
.
ii.
Type the IPv4 address for eth0 interface in dotted-decimal notation and
press Enter.
iii.
Type the subnet mask for the IPv4 address and press Enter.
23
Copyright © 2018, Juniper Networks, Inc.
Step 6: Configure the JA2500 Appliance
