Juniper CTP1000 Series, Руководство по оборудованию

Страница: 48 / 88

•
Compliance with Canadian Regulations on page 38
Compliance with Canadian Regulations
•
Industry Canada Notice on page 38
• Canadian Department of Communications Explanatory Notes on page 39
Industry Canada Notice
• Industry Canada Notice CS-03 on page 38
•
Avis CS-03 d'Industrie Canada on page 38
Industry Canada Notice CS-03
The Industry Canada label identifies certified equipment. This certification means that
the equipment meets certain telecommunications network protective, operation and
safety requirements as prescribed in the appropriate Terminal Equipment Technical
Requirements document(s). The Department does not guarantee that the equipment
will operate to the user's satisfaction. Before installing this equipment, users should
ensure that it is permissible to be connected to the facilities of the local
telecommunications company. The equipment must also be installed using an acceptable
method of connection. The customer should be aware that compliance with the above
conditions may not prevent degradation of service in some situations.
Repairs to certified equipment should be coordinated by a representative designated by
the supplier. Any repairs or alterations made by the user to this equipment, or equipment
malfunctions, may give the telecommunications company cause to request the user to
disconnect the equipment.
Users should ensure for their own protection that the electrical ground connections of
the power utility, telephone lines and internal metallic water pipe system, if present, are
connected together. This precaution may be particularly important in rural areas.
Caution: Users should not attempt to make such connections themselves, but should
contact the appropriate electric inspection authority, or electrician, as appropriate.
Notice: The Ringer Equivalence Number (REN) assigned to each terminal device provides
an indication of the maximum number of terminals allowed to be connected to a
telephone interface. The termination on an interface may consist of any combination of
devices subject only to the requirement that the sum of the Ringer Equivalence Numbers
of all the devices does not exceed 5.
Avis CS-03 d'Industrie Canada
L'étiquette du ministère des Communications du Canada indique que l'appareillage est
certifié, c'est-à-dire qu'il respecte certaines exigences de sécurité et de fonctionnement
visant les réseaux de télécommunications. Le ministère ne garantit pas que l'appareillage
fonctionnera à la satisfaction de l'utilisateur. Avant d'installer l'appareillage, s'assurer
qu'il peut être branché aux installations du service de télécommunications local.
L'appareillage doit aussi être raccordé selon des méthodes acceptées. Le client doit
Copyright © 2015, Juniper Networks, Inc. 38
CTP1000 Series Hardware Guide