Jungheinrich ETV 110, Руководство по эксплуатации

Страница: 103 / 157

E 51 E 51
0 0
8 8
1 1
2 2
. .
G G
B B
LEDs 69-71 are located in keypads 1-3. LEDs 69-71 are located in keypads 1-3.
31 = Cutout after 31 = Cutout after
10 10 se seco cond nds s
Error messages on keypad Error messages on keypad
LED (67) flashes red to indicate LED (67) flashes red to indicate the following errors: the following errors:
– – New master code is already an operator code. New master code is already an operator code.
– – New operator code is already a master code. New operator code is already a master code.
– – Operator code to be changed does not exist. Operator code to be changed does not exist.
– – Tried to change the operator code to another user code that already exists. Tried to change the operator code to another user code that already exists.
– – Tried to delete an operator code that does not exist. Tried to delete an operator code that does not exist.
– – Code memory full Code memory full
7 7 IIS SM M ((
o o
))
Z Z
If the truck is equipped with an ISM access module see “ISM Access Module” If the truck is equipped with an ISM access module see “ISM Access Module”
operating instructions.
operating instructions.
8 8 C Ch ha an ng giin ng g ttrru uc ck k p pa arra am me ette errs s
F F
Changing the truck parameters will affect the behaviour of the truck. This must be Changing the truck parameters will affect the behaviour of the truck. This must be
taken into account when starting up the
taken into account when starting up the truck. truck.
Parameters may only be changed when t Parameters may only be changed when the truck is idle and not lifting. he truck is idle and not lifting.
With the driver’s display it is also possible to change some truck parameters With the driver’s display it is also possible to change some truck parameters
(acceleration, coasting brake, reverse braking, drive direction speed, fork direction
(acceleration, coasting brake, reverse braking, drive direction speed, fork direction
speed and lift speed) and hence the truck’s characteristics.
speed and lift speed) and hence the truck’s characteristics.
t t
Trucks with driver’s display and key switch Trucks with driver’s display and key switch
For trucks with a key switch, use the grey service spanner to access the For trucks with a key switch, use the grey service spanner to access the travel and lift travel and lift
parameters. parameters.
o o
Trucks with driver’s display and CANCODE Trucks with driver’s display and CANCODE
Z Z
Before entering the SERVICE MENU / PARAMETER MENU you will be asked for Before entering the SERVICE MENU / PARAMETER MENU you will be asked for
your pin. The factory setting for
your pin. The factory setting for trucks with CANCODE is ( trucks with CANCODE is (
o o
)) PIN 7295 PIN 7295 ..
To switch on the truck, enter your Pin. Before entering the SERVICE MENU / To switch on the truck, enter your Pin. Before entering the SERVICE MENU /
PARAMETER MENU you will then no longer be asked for your PIN. The parameter
PARAMETER MENU you will then no longer be asked for your PIN. The parameter
settings are saved under your PIN.
settings are saved under your PIN.
You can set 15 different parameters (change of driver or change of program). To
You can set 15 different parameters (change of driver or change of program). To
select other parameter settings, the truck must log off and on again or be switched off
select other parameter settings, the truck must log off and on again or be switched off
and on again. Enter the next PIN.
and on again. Enter the next PIN.
https://www.besttruckmanuals.com/