Jungheinrich EKS 310, Руководство по эксплуатации

Страница: 77 / 97

0708
.GB
F 10
5.2 Securing the driver’s position carriage
The driver’s position carriage can be
secured in the raised position.
– Raise the driver’s position carriage
until the inner mast (1) is above the
carriage (2) of the load lifting safety
device.
– Unscrew the attachment screw (4)
and remove the retaining bolt (3) from
the carriage (2) on the mast.
– Place the retaining bolt (3) on the
vertical hole of the carriage (2) and
secure them.
– Very slowly lower the driver’s position
carriage until the inner mast (1) is
positioned on the retaining bolt.
5.3 Maintaining the lift chains
M
It is important that all lift chains and pivots are at all times kept clean and well
lubricated. Only lubricate discharged chains. A chain must be lubricated with
particular care where it passes over a deflection pulley. Lift chains are safety-critical
parts.
Chains should not have any major contamination. They should only be cleaned with
parafin derivatives e. g. petroleum or diesel fuels. Never clean chains with steam jet
high pressure cleaners, cold or chemical cleaning agents.
5.4 Inspecting the lift chains
Unauthorised wear and external damage:
In accordance with official regualtions, a chain is considered to be worn if it has
extended in length by 3% in the section which passes over the deflection pulley. For
safety reasons, we advise replacing chains when they elongate by 2%.
Chains should also be replaced immediately when visible damage is noted, as such
damage leads to permanent breakage after a certain time.
M
If the truck is fitted with two lift chains, both chains must always be replaced. This is
the only way to ensure even load distribution over the two chains. When replacing
chains the connecting bolts between the chain anchor and the chain must be
replaced. Only new original parts may be used.
1
3
4
2
0708
.GB
F 10
5.2 Securing the driver’s position carriage
The driver’s position carriage can be
secured in the raised position.
– Raise the driver’s position carriage
until the inner mast (1) is above the
carriage (2) of the load lifting safety
device.
– Unscrew the attachment screw (4)
and remove the retaining bolt (3) from
the carriage (2) on the mast.
– Place the retaining bolt (3) on the
vertical hole of the carriage (2) and
secure them.
– Very slowly lower the driver’s position
carriage until the inner mast (1) is
positioned on the retaining bolt.
5.3 Maintaining the lift chains
M
It is important that all lift chains and pivots are at all times kept clean and well
lubricated. Only lubricate discharged chains. A chain must be lubricated with
particular care where it passes over a deflection pulley. Lift chains are safety-critical
parts.
Chains should not have any major contamination. They should only be cleaned with
parafin derivatives e. g. petroleum or diesel fuels. Never clean chains with steam jet
high pressure cleaners, cold or chemical cleaning agents.
5.4 Inspecting the lift chains
Unauthorised wear and external damage:
In accordance with official regualtions, a chain is considered to be worn if it has
extended in length by 3% in the section which passes over the deflection pulley. For
safety reasons, we advise replacing chains when they elongate by 2%.
Chains should also be replaced immediately when visible damage is noted, as such
damage leads to permanent breakage after a certain time.
M
If the truck is fitted with two lift chains, both chains must always be replaced. This is
the only way to ensure even load distribution over the two chains. When replacing
chains the connecting bolts between the chain anchor and the chain must be
replaced. Only new original parts may be used.
1
3
4
2