16
Programming a second indoor station to a bell button (parallel call)
The
parallel call
triggers 2 indoor station from one bell button of the outdoor station. The
floor button only triggers the hard-wired indoor station.
To give the bell button and floor button the same functionality, the
parallel function
must be
used. In this case several indoor stations respond both to the same bell button and to the
same floor button. The parallel function must be set using the commissioning tool.
Note: Repeated programming of an already programmed bell button always only changes the second serial number. If you
wish to change the serial number that was programmed first, you have to delete both serial numbers and then reprogram
both serial numbers again.
1
Initiation
press briefly
LED flashes
Outdoor station in programming mode: flashes,
programming mode of the system is switched on
2a
By means of communication button at the indoor station
◄
6s
►
◄
6s
►
Press communication
button of the indoor sta-
tion briefly (communica-
tion is established with
the outdoor station)
Press button until a
Prog2 tone
and
a NoProg tone and ...
... a positive acknowledge
tone are sounds at the
outdoor and a ring tone at
the indoor stations
1)
release
2b
By means of floor button (indoor station is not accessible)
+
◄
6s
►
◄
6s
►
Press floor button two
times in succession, a
ring tone is sounded
each time
Press button until a Prog2
tone and
a NoProg tone and ...
... a positive acknowl-
edge tone sounds at the
outdoor station and a ring
tone sounds at the indoor
station
1)
release
Repeat steps until all ring tones have been programmed
