Room controller display compact module
Snapping on the adapter frame
The adapter frame is required depending on the switch design range.
￭
With the adapter frame (7) in the correct orientation, snap it from the front onto the mod-
ule (8) (Figure 2). Note the TOP marking.
Mounting and connecting the device
Figure 2: Mounting the controller module
(5)
Supporting frame
(6)
Design frame
(7)
Adapter frame
(8)
Controller module
(9)
Fastening screws
(10)
Design control surfaces
(11)
KNX connection terminal
(12)
Box screws
Supporting frame side A for A design ranges, CD design ranges and FD design. Supporting
frame side B for LS design ranges.
Recommended installation height: 1.50 m.
When the push-button extension module is used (Figure 3): Preferably mounted vertically. Use
large supporting frame (13). When mounting on only one appliance box, countersink the lower
screws into the wall, e.g. with a ø 6 x10 mm hole. Use supporting frame as template.
DANGER!
When mounting with 230 V devices under a common cover, e.g. socket outlets,
there is a danger of electrical shocks in the event of a fault!
Electrical shocks can be fatal.
Do not install any 230 V devices in combination with a push-button sensor extension
module under a common cover!
￭
Mount supporting frame (5) or (13) in the correct position onto an appliance box. Note
marking TOP=; marking A or B in front. Use only the enclosed box screws (12).
￭
Push frame (6) onto supporting frame.
￭
Mount push-button extension module (14) preferably below. Route connecting cable (16)
between supporting frame and intermediate web.
￭
Push-button extension module: Insert connecting cable (16) in the correct orientation into
slot (15) in the controller module. Do not crimp the connecting cable (Figure 3).
4 / 7
32573243
16.04.2020
J:0082573243
