Suppression length, effective
output
0 ms … 300 s
Basic setting: 0 ms
Triggers for event-controlled
transmission are often switch-
on and switch-off operations.
In order to avoid incorrect
measured values due to
switch-on peaks, this
parameter can be used to
enter a suppression period.
The measured values are only
transmitted if the effective
output is still above or below
the relative threshold value
after the set time.
Averaging length
0.2 … 300 s
Basic setting: 1 s
In the case of effective output,
it is not the current value
which is transmitted, as with
other measured values, but
the average value. It is
possible to set the period for
average value formation here.
Information window
During channel selection in the Information window, the following values are displayed.
Display value
Explanations
Measuring status:
value is real/
out of service
value is real: Device being operated
out of service: Device error
Measuring status:
no fault/
value is corrupted due to failure
no fault: Measurement active
value is corrupted due to failure: The sensor is
not supplying valid measured values.
Measuring status:
in commission
Not used.
Measuring status:
time synchronisation active
Not used.
Measuring status:
Acknowledged
Not used.
Measuring status:
no alarm
Not used.
Voltage
Displays the current voltage value.
Current
Displays the current current value.
Effective output
Displays the current effective output.
Idle output
Displays the current idle output.
If negative values are displayed, this is a
capacitive idle power. Positive values show an
inductive idle power.
Apparent output
Displays the current apparent output.
Absolute effective energy
Displays the current absolute effective energy.
If negative values are displayed, then effective
energy is fed in, e.g. via a photovoltaic
system.
Effective energy
Displays the cumulated effective energy.
Counter status can be set via settings window.
7/8
82582003
J:0082582003
14.03.2014
eNet
Radio energy detector, 4-channel, for rail mounting
