with Ø 1.5 mm²
max. 300 m
with Ø 1.0 mm²
max. 238 m
with Ø 0.75 mm²
max. 174 m
with Ø 0.5 mm²
max. 116 m
Housing
Fitting width
72 mm / 4 modules
Connection of power supply and DALI
Connection mode
Screw terminal
Single stranded
0.5 ... 4 mm²
finely stranded without conductor sleeve
0.5 ... 4 mm²
finely stranded with conductor sleeve
0.5 ... 2.5 mm²
KNX
KNX medium
TP 1
Commissioning mode
S mode
Rated voltage KNX
DC 21 ... 32 V SELV
Power consumption KNX
typical 150 mW
Connection type for bus
Connection terminal
6.2 Troubleshooting
Display shows Er, connected DALI devices have no function, no operation possible
Cause: Mains voltage on DALI cable.
Installation error. Disconnect device and connected DALI devices from mains voltage and
disconnect bus voltage. Correct installation.
Display shows bc in manual mode, control of individual luminaires not possible.
Cause: The device has not been programmed.
Program device, put DALI system into operation.
Individual DALI devices have no function
Cause 1: Load is defective, e.g. lamp.
Exchange load.
Cause 2: DALI device is defective.
Exchange defective device.
Switch on voltage.
Press
c
and
ALL OFF
buttons together for at least 10 seconds.
The device detects the exchanges DALI device and loads in the necessary data. The
display (4) shows
LE
.
i
Simultaneous exchange of multiple DALI devices is only possible with commissioning
software and project data.
Manual control with button field not possible
Cause 1: Manual control has not been programmed.
Program manual control.
Cause 2: Manual control via bus disabled.
Enable manual control.
DALI group cannot be operated
Cause: DALI group disabled via bus or manual operation.
Cancel disabling.
None of the DALI groups can be operated.
Cause 1: All DALI groups disabled via bus or manual operation.
Cancel disabling.
Cause 2: Continuous manual mode switched on.
Deactivating permanent manual control.
7/8
82559913
J:0082559913
16.08.2010
DALI gateway
