LB management
Brightness / temperature sensor Bluetooth
Operation as brightness sensor: Select the installation location on the window pane so that the
sunlight hits the sensor unobstructed even when the sun protection is active. Shadows produce
incorrect measured values.
Mounting the sensor
The contact surface of the substrate must be dry, clean and free of grease.
Figure 7: Underside of housing with adhesive pads
￭
Apply adhesive pad (5) to underside of housing (Figure 7). Remove the protective film on
one side, place it on the underside of the sensor housing and press it down firmly. The
light guide (4) for brightness measurement must not be pasted over.
￭
Remove the protective film from the adhesive pad, place the sensor on the surface and
press firmly.
Dismounting the sensor
￭
Detach the sensor from the surface by rotating it alternating clockwise and counterclock-
wise.
5
Technical data
Rated voltage
DC 3 V
Battery type
1×lithium CR 2450
Brightness measurement
5 ... 80,000 lx
Temperature measurement
-5 ... +55 °C
Ambient temperature
-5 ... +55 °C
Storage/transport temperature
-20 ... +70 °C
Dimensions L×W×H
56 x 32 x 13 mm
Transmitting range
typ. 10 m
Radio frequency
2.402 ... 2.480 GHz
Transmission capacity
max. 2.5 mW, Class 2
6
Conformity
Albrecht Jung GmbH & Co. KG hereby declares that the radio system type art. no. 1792HTBT
meets the directive 2014/53/EU. You can find the full article number on the device. The com-
plete text of the EU Declaration of Conformity is available under the Internet address:
www.jung.de/ce
7
Warranty
The warranty is provided in accordance with statutory requirements via the specialist trade.
4 / 5
82599913
11.11.2019
J0082599913
