LB management
KNX RF push-button
7.2 Commissioning
Programming the physical address and application program, 1-channel (Figure 5) and 2-
channel (Figure 6)
Project design and commissioning with ETS from version5.7.5and above.
Figure 5: Activating programming mode (1-channel)
Figure 6: Activating programming mode (2-channel)
Precondition: The device is connected and ready for operation.
￭
Activate programming mode: Press the top right button and bottom right button simultan-
eously and hold for longer than 4 seconds (Figure 5).
The Status LED flashes red. Programming mode is activated.
When the programming mode is activated, telegrams can be sent to the bus.
￭
Programming the physical address.
The status LED returns to its previous state. Physical address is programmed.
Prerequisite for the "Touch dimmer" insert: Load is connected to the insert.
￭
Programming the application program.
9 / 12
32403803
03.11.2021
J0082403803
