Jumpking Ultra JumpPOD, Руководство пользователя

Страница: 15 / 22

15
ASSEMBLY
1. Make sure you understand the information in
the box at the top of this page before you
begin assembling the trampoline.
Lay two Top Tubes (1) on the ground as shown.
Make sure there is a Enclosure Socket (2) on each
Top Tube. Insert the end of one Top Tube into
the Enclosure Socket on the other Top Tube.
Insert a Leg (3) into one of the Enclosure Sockets (2).
Insert a Base (4) into the Leg; make sure the center of
the Base is pointing down. Slide a second Leg
onto the Base. This Leg will be next to the empty
Enclosure Socket. Step on the Top Rail (1) next to the
Enclosure Socket, lift the Leg, and insert the Leg into
the empty Enclosure Socket.
You have now assembled one leg section.
Repeat this step to assemble 3 more leg
sections.
IMPORTANT ASSEMBLY INFORMATION
•
No tools are required for assembly. However, a
rubber mallet may make assembly easier.
•
Assembly requires two persons.
•
Use gloves to protect your hands from pinch
points during assembly.
•
The assembly steps refer to parts by their descrip-
tions and key numbers (see the PART LIST on
page 23). If a part is missing, see ORDERING
REPLACEMENT PARTS on page 22.
TRAMPOLINE PLACEMENT
1. Place the trampoline on a level surface
before use.
2. Adequate overhead clearance is essential. A
minimum of 7.3 m (24 ft.) from ground level is
recommended. Provide clearance for wires,
tree limbs, and other possible hazards.
Lateral clearance is also essential. Place the
trampoline away from walls, structures,
fences, and other play areas. Maintain a clear
space on all sides of the trampoline.
3. Use the trampoline in a well-lighted area.
Artificial illumination may be required for
shady areas.
4. Secure the trampoline against unauthorized
and unsupervised use.
5. Remove any obstructions from beneath the
trampoline.
6. The owner and supervisors of the trampoline
are responsible to make all users aware of
practices specified in this manual.
1
2
1
3
2
3
(4) Center
2. Note: This step requires two persons. During
this step, you will connect the four leg sec-
tions.
Hold two leg sections in the positions shown.
Insert the small end of one Top Tube (1) into the
Enclosure Socket (2) on another Top Tube.
Repeat this step until all four leg sections are
connected.
2
1
2
A
B
Screw holes
Screw holes