6
USB Power
Your
Jump-N-Carry
features a USB outlet. To active the USB outlet, quickly press the
Light Button on the control panel. You should see the USB status light, located next to
the USB outlet, light green. This indicates the USB outlet is now powered.
LED Work Light
Your
Jump-N-Carry
is equipped with a high intensity LED work/flash light for use when
jump starting at night or when additional light is needed to complete a task.
To turn the light on, press and hold the Light Button on the control panel for 3 seconds.
12 Volt DC Power
Your
Jump-N-Carry
is an essential tool for all who replace automobile batteries.
Most vehicles have electronic components with memory, such as alarm systems,
computers, radios, phones, etc. and when the vehicle’s battery is replaced, the memory
is lost. However, if the Male-Male Extension Cord is connected from the
Jump-N-Carry
to the 12 Volt outlet on the vehicle, the memory can be saved.
Note:
To use the
Jump-N-Carry
for this purpose, the chosen outlet must be live
whenthe vehicle is turned OFF. On some vehicles, 12 Volt outlets are deactivated
when the vehicle is turned OFF.
Your
Jump-N-Carry
is also a portable power source for all 12 Vdc accessories
equipped with a male 12 Volt plug. The DC outlet on the
Jump-N-Carry
has automatic
overload protection.
When your
Jump-N-Carry
is used with a DC to AC power inverter, it can operate
appliances normally powered by 120 Vac or 220 Vac. Recommended inverter for the
portable power source is 400 watts maximum. For more information, contact your
nearest
Jump-N-Carry
dealer.
Air Compressor Instructions
1. Remove valve stem cap and connect compressor hose to the valve stem.
2. Turn on the air compressor and use the gauge to monitor the tire’s pressure.
3. Once the tire has reached the appropriate PSI (noted on the tire or in the Owner’s
Manual), turn off the compressor.
4. Disconnect the compressor hose and return to storage clip. It is always good practice
to test the tire pressure with an independent and properly calibrated tire gauge.
5. Replace valve stem cap.
Note:
The
Jump-N-Carry
air compressor features an overheating protection
switch that could result in a temporary shut-down of the air compressor while in
use, if recommended operating temperature is exceeded. After cooling, the air
compressor will reset itself and resume normal operation.
Your air compressor is equipped with a permanently lubricated, maintenance free motor.
Never try to lubricate the compressor.
Содержание JNC550A
Страница 11: ...11 ...
