Jumbuck HS-UM011SB, Инструкция по сборке и эксплуатации

Страница: 22 / 32

GAS CYLINDER USE
GAS CONNECTIONS
In the case of a problem arising with the hose and regulator please contact your BBQ supplier for
a list of approved replacement parts .The hose and regulator assembly parts must be an Australian
Gas Association approved part.
LEAK TESTING
This should be done the first time you connect up the barbecue, and again every time you
disconnect and reconnect any fitting. Inspect the hose before each use .
Turn the gas on at the cylinder, or make sure gas is available to the barbecue, but do not turn the
burners on .This fills the gas lines with gas. Now brush or pour some soapy water onto all
connections. If there is a leak, bubbles should appear within about 20 seconds. If you find any
leaks, tighten the connection. If the leaks persist, contact your place of purchase.
As an alternative, you may use a gas leak detector, following the manufacturer’s instructions,
available at all major barbecue retailers. This provides an easier way to check for leaks.
DO NOT USE NAKED FLAME FOR LOCATING GAS LEAKS.
IF A LEAK PERSISTS, CALL AN AUTHORISED PERSON
WARNING
STORE CYLINDER IN A WELL VENTILATED AREA
OUT OF REACH OF CHILDREN