B
Dear Customer!
The assembly of your new house requires
a bit of technical knowledge. However, it is
important that the assembly instructions are
followed strict-ly. The assembly instruction
is a combination of text and illustrations. The
profiles are packed in separate numbered packs
corresponding to the order in the assembly
instruction. Erect one pack at a time. All nuts
and bolts and fittings are found in bag No. 0
(specified on page 12). Each pack is specified in
separate lists of components.
All detailed illustrations are marked with
symbols:
Seen from inside Seen from outside.
Precautions.
•
Assembly must only be carried out in dry
and calm weather.
•
Always use working gloves while glazing.
Greenhouse glass has sharp edges,
especially if the glass breaks.
•
Assistants and especially children must be
warned that broken glass is an element of
danger. Pick up broken glass at once and
remove it with care.
•
We recommend to use protective glasses
while fixing the spring wire clips.
•
Place the ladder on a level support.
•
It is essential to have an assistant.
References
The column marked indicates the
page(s) on which the component is used.
Page 13:
Foundation
The base is not included in this delivery.
However, an original base can be bought
separately. It ensures you a stable and easy to
build base.
If you make your own base the measurements
indicated must be external measurements.
If you buy an original base you furthermore
need about 75 litres of concrete and 6/8
plastic-/concrete pipes of about 800 mm which
are placed in a non-freezing depth for the
fastening of the corner and middle anchors.
The base must be 100% level and square; the
latter is ensured by checking that the two
diagonal measurements are equal.
Tools
The mounting of the greenhouse requires the
tools shown on page 12.
Page 14-27:
Place the components as shown on the
illustration and assemble in the order shown
in the pictures. Do not tighten the nuts
completely until the front gable construction
has been assembled.
Page 13:
(Fastening to the base).
When constructing your own base you have
to drill holes (7 mm) in the ground frame
between all the vertical frames, the greenhouse
is then fastened to the base with screws (A).
Using an original base the greenhouse is
fastened to each vertical bar as shown on
drawing B/C.
Page 24-27:
For an easier assembly we recommend that you
oil the screws for the doors.
Fitting of glass/polycarbonate
Important before glazing!
Make sure that gables and sides are level and
square, and that door(s) and window(s) are
functioning perfectly.
Best order of assembly:
1) Windows – 2) Roof – 3) Doors – 4) Gables
– 5) Sides
Page 30-33:
Glazing (illustration 1 to 8)
Degrease the sheets and frames with spirit.
Start glazing from below, one glass at a time.
Apply a 3 mm silicone line on the vertical
frames where indicated (dotted lines on
the illustration). (A 3 mm line of silicone is
sufficient to obtain maximum attachment). If
you do use more than recommended, you can
buy extra tubes.
Spring wire clips and glassholders are to be
fitted as shown.
X = Spring wire clips, > = Glassholders
In case of broken glass carefully pull it
outwards and loosen the silicone by means of a
sharp craft knife.
Clean the profile completely before inserting a
new pane of glass.
Page 34-37:
Mounting of polycarbonate
The illustrations at the bottom of page 34/36
show where to mount the polycarbonate plates
and lists. The type indication states the length
in mm. A possible adjustment is made by
means of a fine-tooth saw.
NB! To avoid the formation of algae the
polycarbonate sheets must not come into
contact with the ground. Rest them on a piece
of cardboard.
A-lists are mounted as shown on page 35/37.
Put the sheet into the bottom list, bend the
sheet slightly outwards and put it in the top list.
M-lists are mounted as shown on page 35/37.
Place the upper part of the list under the alu.
profile in the whole length of the sheet and
hereafter click on the list from above.
Sealing of the polycarbonate sheets
The sheets may be sealed against insects.
Close the top end off with alu-tape or silicone.
The bottom only with airstrip tape to let
condensation out (available at your local
dealer).
Now your greenhouse is completely assembled.
However, please notice the following:
Maintenance
•
Grease doors (hinges and lock).
•
Clean the gutter for leaves, etc.
•
Adjustment of windows.
•
Replacement of broken glass.
•
Clean the house with disinfectant before
and after the growing season.
Winter Protection
In areas with occurrence of snow we
recommend the following winter protection:
•
Support the roof ridge at the centre of the
house.
•
Remove greater snow loads from the roof.
•
Take precautions against snow falling
down from for instance a tree or a roof.
•
Dismount the cylinders for the automatic
window openers, if any (optional extras).
•
Secure door(s) and window(s) preventing
wind damage to the house.
Insurance
Please note that not all insurance companies
cover glasshouses automatically. Please
contact your insurance company to ensure an
insurance coverage.
Guarantee
Juliana grants a guarantee of 12 years which
covers replacement of faulty parts. The
guarantee does not cover polycarbonate, glass,
transport, assembly, freight etc.
Juliana grants a guarantee of 2 years on painted
parts, if any. Note that marks in the painting
may occur due to suspension of the profiles.
The guarantee is invalid if the greenhouse is
not assembled according to these instructions.
Complaints
All our greenhouses are built to high standards
of quality. However, should a complaint
occur please contact your dealer at once.
Remember to specify the defect by indicating
the greenhouse model and number of the
component and the quality control number.
May we congratulate you on your new greenhouse
GB
USA
DEAR CUSTOMER
Congratulations on purchasing your new
greenhouse. It is important that you follow these
assembly instructions step-by-step.
The assembly instructions are a combination of text
and illustrations. The profiles are packed in separate,
numbered packs corresponding to their order of use
in the instructions. Assemble one pack at a time. All
nuts, bolts and fittings are contained in bag No. 0.
Each pack is specified in separate lists of
components.
All detailed illustrations are marked with the
following symbols:
Seen from the inside Seen from the outside
SOME SAFETY PRECAUTIONS
•
Assembly must only be carried out in dry and
calm weather.
•
Always wear work gloves when installing the
glazing. Greenhouse glass has sharp edges,
especially if it breaks.
•
Assistants and especially children must be
warned that broken glass is dangerous. Pick
up all broken glass at once and remove it with
care.
•
We recommend that you wear protective
glasses while fixing the spring wire clips.
•
Any ladders that are used must be placed on a
level surface.
•
It is essential to have an assistant available.
PAGE 12: TOOLS
Assembling the greenhouse requires the tools
shown on page 12.
PAGE 15: FOUNDATIONS
The base is not included in this consignment, but an
original base/wall can be purchased separately. This
base is easy to construct and will guarantee you a
stable base for your greenhouse.
If you construct your own base, the specified
measurements must be external measurements.
If If you buy our original base/wall, the anchor legs
must be cast in cement in eight places. These eight
holes must be dug out to below the frost line (800
mm). Place the assembled base with anchor legs
over the holes so the anchor legs fit into the holes; it
takes about 75 litres of concrete to fill up the holes.
Make sure the base is completely level and square.
To square the base, make sure the two diagonal
measurements are identical.
The width of the front and back gables must also be
identical.
ATTACHMENT TO THE BASE/WALL
If you build the base yourself, drill holes that fit the
size of the screws you have purchased and choose
screws that are appropriate for the wall material,
The greenhouse must then be secured to the base
using screws (A).
If you are using an original base/wall, attach the
house using the self-tapping screws included for the
pre-drilled holes.
PAGE 16-27: ORDER OF ASSEMBLY
Place the components as shown on the illustration
and assemble in the order shown in the pictures. Do
not tighten the nuts fully until the entire sub-frame
has been assembled.
PAGE 20-23: ROOF
The two automatic openers should be frequently
adjusted and at least twice a year in response to
major temperature changes.
The cylinder allows travel of 20–30 mm for the hood.
The actual cylinder can be moved up and down. If
the rod is in the lowest position, the travel will be
greatest. If the cylinder is moved upwards, there will
be less travel.
If you wish to close the hood completely, move the
cylinder to its lowest position and lock it in place by
turning the screw towards the cylinder. Do not over-
tighten the screw.
PAGE 24-27: DOORS AND WINDOWS
For easier assembly, we recommend that you oil the
screws for the doors. The glass or polycarbonate for
the door(s) and windows must be fitted at the same
time as the profiles.
PAGES 28-31: FITTING OF GLASS
Important before assembly!
Make sure that the gables and sides are level
and square and that door(s) and window(s) are
functioning perfectly.
The best order of assembly for the glass:
Windows - Doors - Roof - Gables - Sides
Glass installation (illustrations 1 to 8)
Degrease the sheets and frames with spirit.
Start glazing from the bottom, one pane at a time.
Apply a 3mm silicone bead around the vertical
frames as indicated (the dotted lines on the
illustration). (A 3mm bead of silicone is sufficient to
ensure maximum adhesion). If you use more silicone
than recommended, extra tubes can be purchased.
If you accidentally break a pane, carefully pull the
broken glass outwards and loosen the silicone using
a sharp craft knife.
Clean the profile completely before inserting a new
pane of glass.
M-strips are fitted as shown on pages 29. Place the
upper part of the strip under the aluminium profile
along the full length of the sheet and then click the
strip into position from above.
Your greenhouse is now fully assembled. However,
please note the following:
MAINTENANCE
•
Grease the doors (hinges and locks).
•
Keep the gutters free from leaves, etc.
•
Adjust the windows as necessary.
•
Replace any broken glass.
•
Clean the greenhouse with disinfectant before
and after the growing season.
WINTER PROTECTION
If you anticipate snow during the winter, we
recommend the following winter precautions:
•
Support the apex of the roof in the middle.
•
Remove any deep snow from the roof.
•
Take precautions to prevent snow falling from
a tree or roof, for example.
•
Adjust the cylinders for the opening of the
hood.
•
Secure the door(s) and window(s) to prevent
wind damage to the greenhouse.
WATER AND CONDENSATION
Please note that your greenhouse is not like a
conservatory, for example, and that you should
therefore be aware that the greenhouse may leak
during or after precipitation and that condensation
will occur on the inside of the greenhouse. Good
ventilation will help prevent condensation.
INSURANCE
Please note that not all insurance companies cover
greenhouses automatically. Please contact your
insurance company to ensure that your greenhouse
is covered.
GUARANTEE
Juliana greenhouses are covered by a 12-year
guarantee, which covers the replacement or repair
of faulty parts. The guarantee does not cover
polycarbonate, glass, transport, assembly, freight,
etc.
Juliana greenhouses are covered by a two-year
warranty on painted parts, where fitted. Note that
marks on the paint may occur due to suspension of
the profiles.
The guarantee will be void if the greenhouse is not
assembled in accordance with these instructions.
COMPLAINTS
All our greenhouses are built to the highest quality
standards. However, should you experience any
problems, please contact your dealer at once. When
describing the defect, please state the greenhouse
model, the component number.
Any suspension marks or shiny ends on painted
Juliana profiles will not be visible after the
greenhouse has been assembled.
Congratulations on your new greenhouse, which we
hope will bring you a lot of pleasure for many years
to come.
Yours sincerely,
Juliana Drivhuse A/S
Содержание F09730
Страница 14: ...14...
