Working with your Pearl
28
Displaying and correcting the timer
To display the remaining running time while the unit is
in operation, press the timer key
once.
The remaining time will be displayed and can be modi-
fied with the arrow keys
.
If no value is entered, the display will eventually re-
turn to the measured current temperature and the
previously set remaining time will be active.
Alarm has triggered
An audible signal (loud beeping noise) is emitted when
the timer has run out. The display blinks at the same
time.
To switch off the signal, press
.
The time covered by the timer will be stored and
used as the preset value the next time the timer is
activated.
Switching off the timer
You can switch off the timer at any time while the
unit is in operation by pressing and holding the timer
key
for at least two seconds. The signal will be
triggered and must be switched off with
.
However, the timer value that is in use will remain in
memory and will be shown as the preset value the
next time the timer is set.
Switching
off the signal
