Julabo Corio C, Оригинальное руководство по эксплуатации

Страница: 23 / 36

Operation
23
8 Operation
8.1 Switch on the unit
This section describes how to switch on the device.
 The device is connected and ready for operation.
1. Switch the unit on at the mains switch.
 All display elements light up briefly, the software boots and starts the
device.

The device is switched on and ready for operation. The display shows
“OFF”. If the auto start function is activated, then the device starts directly
into the last setting.
8.2 Switch off the unit
This section describes how to switch off the device.
 The device is switched on.
1. Stop a running temperature control application.
2. Switch the device off at the mains switch.

The device is switched off.
8.3 Configuring setpoint temperature
Device is running the temperature control application to the configured setpoint
temperature. The factory setting is 10°C. The setpoint temperature can be
changed while the temperature control application is running. The set value is
saved.
 The unit is switched on.
1. Press one of the arrow keys briefly.
 The display switches from the actual value display to the setpoint display,
then shows the last saved setpoint temperature. The digits before the
decimal point flash.
2. Use the arrow keys to set the value before the decimal point and confirm
with [OK] .
 The set value is applied. The decimal point flashes.
3. Use the arrow keys to set the value after the decimal point and confirm with
[OK] .
 The set value is applied. The new setpoint temperature flashes briefly.

The setpoint temperature is set and active.