Jula Meec tools 012586, Руководство по эксплуатации

Страница: 27 / 29

EN
37
2. Remove the battery by pressing the clips
and pulling out the battery.
START/SWITCH OFF
1. Use the power switch to start the power
tool and keep it pressed to run the tool.
2. Increase the speed by pressing the power
switch. The more the power switch is
pressed, the faster the speed.
3. Switch off the tool by releasing the power
switch.
DRILLING AND SCREWING
Set the switch to the symbol “Drilling and
screwing”.
PERCUSSION DRILLING
Set the percussion selector to the symbol
”Percussion drilling”. The switch snaps into
position. The percussion selector can also be
used when the motor is running.
RIGHT/LEFT DRIVE
NOTE:
The tool must have stopped before the drive
selector for right/left drive can be used.
Otherwise you could damage the tool.
Use the switch to switch between right and
left drive. When the switch is in the middle
position the power switch is locked and cannot
be pressed. Before putting away the tool you
should always put the drive selector in the
middle position so that the tool cannot be
started by mistake.
operating conditions (taking into account all
stages of the work cycle, e.g. the time when
the tool is switched off and when it is idling,
in addition to the start-up time).
DESCRIPTION
1. Percussion selector
2. Right/left drive selector
3. Power switch On/Off
4. Battery compartment
5. Support handle
6. Chuck SDS+
7. Drill/chisel selector
FIG. 1
USE
CHARGING THE BATTERY
• The battery must be fully charged before
using it for the first time. Otherwise the
battery will not achieve its full capacity.
• Make sure that the battery is the right
way round when putting it in the charger.
Do not press too hard when inserting the
battery.
• Remove the battery from the charger after
1 hour. Unplug the charger from the
mains before removing the battery from
the charger.
IMPORTANT:
Only use the supplied charger to charge the
battery.
INSERTING/REMOVING THE
BATTERY
1. The battery is inserted in the tool by
pushing it into the battery compartment
slot. The battery should snap fully in place
so that the clips lock.