
ENGLISH
46
Use
Unlock the safety latch by pressing the yellow pin
on the right side of the steam gun to the left. Hot
steam will shoot out when the steam control is
pressed in. First hold the steam gun over a cloth to
soak up the water that comes in the beginning.
Turn the steam switch until there is a steady flow
of steam. You can now start to clean.
Do not hold the steam nozzle too far from the
surface to be cleaned. Loosen up the dirt by
moving the nozzle back and forth. The amount of
steam is controlled by the steam button and can be
adjusted according to how dirty it is. Turn the
steam button clockwise for less steam and anti-
clockwise for more steam.
The appliance must not be tilted more than 45°
during use. Always stand the appliance on a firm
surface. A full tank lasts about 50 minutes. Never
leave the appliance unsupervised when switched
on. Lock the steam control with the safety latch, if
necessary. Lock the safety latch by pressing the
yellow pin on the left side of the steam gun to the
right.
WARNING!
The casing and accessories become very hot during use. Let the appliance cool before changing
accessories. The tank is pressurised. Never open the filler cap while the appliance is switched on.
WARNING!
Never direct the jet of steam at people, animals, plants or electrical systems – risk of accidents.
NOTE!
Residual steam may continue to seep out for a few seconds after turning the steam function off.
NOTE!
The appliance has overheat protection which automatically shuts it off when it reaches 180°C. Unplug the
power cord. Leave to cool for 30 minutes before using it again.
Filling with water
Fill the water tank if the steam starts to abate. Stop the machine using the ON/OFF switch. The green
operation indicator light goes out. Press the steam control until steam no longer comes out and then lock
the control. Unplug the power cord and allow the appliance to cool. Carefully open the filler cap by
pressing it down and turning it anti-clockwise.
WARNING!
Hot steam may escape when opening the cap. You can burn yourself on the cap threads and the tank.
Top up with water using the measuring jug and funnel (see Filling with water) and then replace the filler
cap. Plug in the power cord and turn on the appliance again. The appliance is ready for use when the
indicator lamp for heating goes out.
Содержание 802-337
Страница 49: ......