– 2 –
4. Installing the oil pan
Fix the oil pan supplied with the unit on the table using the six nails.
Insert the felt supplied with the machine between the table and the oil
pan.
5. Fit hinge into the opening in the machine bed, and
fi
t the machine
head to table rubber hinge before placing the machine head on rubber
seats on the four corners.
6. Securely attach head support rod to the table until it goes no further.
2. ADJUSTING THE BELT TENSION
WARNING :
To avoid possible personal injury due to abrupt start of the machine, turn off the power to the machine and check to be sure that the
motor has totally stopped rotating in prior.
Adjust the belt tension with the height of the motor so that the belt sags
15 mm when the center of V belt is applied with a 9.8 N load.
15 mm
9.8 N
Handwheel
Motor pulley
Hinge
Head support rod
Hinge
Hinge
– 3 –
4. ATTACHING THE BELT COVER
3. INSTALLATION OF THREAD STAND AND BOBBIN WINDER
WARNING :
To avoid possible personal injury due to abrupt start of the machine, turn off the power to the machine and check to be sure that the
motor has totally stopped rotating in prior.
WARNING :
To avoid possible personal injury due to abrupt start of the machine, turn off the power to the machine and check to be sure that the
motor has totally stopped rotating in prior.
5. INSTALLATION OF THREAD GUIDE PIN
