JUKI LK-1900S Series, Инструкция по эксплуатации

Страница: 73 / 92

－
71
－
Error code Indication Description of error Corrective measure Remarks
E908 Y origin retrieval error
Y origin sensor does not change.
Turn OFF the power switch
and check whether CN43
and/or CN54 of the MAIN
board are disconnected or
loose.
E910 Work clamp foot origin retrieval error
Work clamp foot origin sensor does not
change.
Turn OFF the power switch
and check whether CN71 of
INT board or CN44 of MAIN
board is disconnected or
loose.
E914 Feed trouble error
Timing lag between feed and main shaft
has occurred.
Turn OFF the power switch
and check whether coupling
of the main motor is loose.
E915 Communication error between panel
and MAIN
Communication between the panel and
MAIN cannot be performed.
Turn OFF the power switch
and check whether CN34 of
MAIN board is disconnected
or loose.
E916
Communication error between MAIN
and SDC
Communication between MAIN and SDC
cannot be performed.
Turn OFF the power switch
and check whether CN32 of
MAIN board or CN15 of SDC
board is disconnected or
loose.
E918
MAIN board overheat
Overheat of MAIN board
Turn OFF the power switch
and turn ON the power switch
again after some time.
E943 MAIN memory write-in trouble
Memory write-in of MAIN board cannot be
performed.
Turn OFF the power switch
and check the insertion of
ROM of U022 of MAIN board.
E946 INT memory write-in trouble
Memory write-in of the head board cannot
be performed.
Turn OFF the power switch
and check whether CN30 of
MAIN board is disconnected or
loose.
-
Power supply fault, connector discon-
nection
The supply voltage specification is not cor -
rect.
The connector has dropped off.
Turn OFF the power switch.
Check the supply voltage,
and check the CN3 of the
FLT board and CN13 of the
SDC board is disconnected
or loose.