JUKI IP-410, Инструкция по эксплуатации

Страница: 15 / 133

– 11 –
2-5. Specifying the position
The figure on the right-hand side is the position specifying screen
whch s dsplayed when specfyng the poston at the settng of
functon. The selected functon code s dsplayed at
J
.
1
Press MOVE key
A
.
The presser and the present needle poston dsplay
M
move n the pressed drecton, and the coordnate value
dsplay
L
s updated. Whle MOVE key s held pressed,
the presser moves n the pressed drecton, and when t s
detached, the move of presser stops.
When the presser moves to the target poston and PASSING
POINT button
B
or DECIDING POINT button
C
s pressed, the poston s nputted as the shape pont
or the needle entry pont. At
K
the number of nput ponts
s dsplayed. PASSING POINT button
B
may not be
dsplayed accordng to the selected functon.
2
Press BACKWARD button
D
after moving with MOVE
key.
The poston returns to the preceedng determned poston.
When t s pressed mmedately after the determnaton of nput
poston, one pont of the determned nput ponts s cancelled
and the poston returns to the nput pont before one pont.
3
Press ENTER button
E
.
The outer presser automatcally returns to the poston where
nput was started, traces the element whch was operated and
created at the nput pont nputted untl then, moves to the last
of the element, and the data s nserted.
(Wth/wthout trace can be selected. For the detals,
refer to
"10. SELECTING ENDING PROCEDURE" p.95
.)
K
J
A
D
E
B
C
L
H G
M