JUKI DLU-5494N-7/IP-110C, Руководство по установке, Страница: 4 / 10

–­2­– –­2­– –­2­–
When­the­p.c.b.­is­installed,­insert­the­cable­to­SC-90­following­"Instruction­Manual­for­DLU-5494N-7/
SC-90/M-9/IP-0C/KT-0",­and­connect­the­cable­to­KT-0(EPF)­p.c.b.­following­the­steps­below.
9.­ After­inserting­the­connector,­put­all­cords­
together­with­cable­clip­band­
!4
­located­on­the­
side­of­the­box.
­ At­this­time,­bundle­the­connectors­which­are­
arranged­above­the­wire­saddle­to­wire­saddle­
!5
­and­those­which­are­arranged­below­the­wire­
saddle­to­wire­saddle­
!6
.
* For installing from M-91 motor to SC-910 control box or installing SC-910 control box on the table,
refer to "Instruction Manual for DLU-5494N-7/SC-910/M-91/IP-110C/KT-01".
1. Fix the cord clamp and the cable clip band following the attaching procedure.
(Refer to "Instruction Manual for DLU-5494N-7/SC-910/M-91/IP-110/KT-01".)
2. When removing the connector, remove it from the wire saddle and remove it while pressing the
hook of the cable clip band.
4.­ Securely­fix­KT-0(EPF)­p.c.b.­A­(asm.)­
1
­to­
the­control­box­main­unit­using­three­screws­
4
­
supplied­with­the­unit­as­accessories.
3.­ Insert­KT-0(EPF)­p.c.b.­A­(asm.)­
1
­to­connector­
CN47­
3
­of­the­main­unit­as­illustrated.
Do not forcibly press the circuit board.
5.­ Connect­6P­connector­
5
­coming­from­the­
machine­head­to­connector­
9
­(CN39).
6.­ Connect­4P­connector­
6
­coming­from­the­
machine­head­to­connector­
!0
­(CN34).
7.­ Connect­4P­connector­
7
­coming­from­the­
operation­display­panel­to­connector­
!1
­(CN32).­
8.­ Insert­KT-0(EPF)­relay­connector­
8
­to­
connector­
!2
­(CN4)­and­connector­
!3
­(CN42).
1
3
4
!5
!4
!6
5
9
6
7
!3
!1
8
!0
!2
When the connectors are not properly
connected, the p.c.b. does not work
normally.