JUKI DLU-5494N-7/IP-110C, Руководство по установке, Страница: 3 / 10

­–­­– ­–­­– ­–­­–
There­are­cases­where­the­control­box­to­be­used­
may­not­be­utilized.­Check­that­REV.­No.­
1
­as­
shown­in­Fig.­A­is­after­"02".­If­the­number­is­before­
it,­the­control­box­cannot­be­used.
On­the­occasion­of­using­DLU-5494N-7/IP-0C,­check­that­the­products­(parts)­below­are­on­hand.
When­the­parts­to­be­used­are­ready,­install­the­extension­p.c.b.­on­SC-90­following­the­procedure­below.
1. CHECK AT THE BEGINNING
(1) Control box to be used
(2) List of parts to be used
2. SETUP OF THE HARDWEAR
.­ DLU-5494N-7­machine­head
2.­ IP-0C­panel
3.­ SC-90­control­box
4.­ M-9­motor
5.­ Extension­p.c.b­(KT-0(EPF)­p.c.b.)­for­DLU-5494N-7­
.­ Open­the­front­cover­and­upper­cover­according­
to­the­instructions­given­in­the­Instruction­Manual­
for­the­control­box­main­unit.
(1) Attaching the circuit board
2.­ Insert­stud­
2
­supplied­with­the­unit­as­
accessories­to­KT-0(EPF)­p.c.b.­A­(asm.)­
1
.
Be careful of the inserting direction.
Fig. A
Inserting position
Rear side
1
1
2