juju Total 360, Руководство пользователя, Страница: 13 / 47

Page 13
noticeable immediately. It should therefore be replaced.
25. Please read the car manufacturer’s handbook during use of child restraint system
with ISOFIX.
Use in the vehicle
!!! Only suitable if the approved vehicles are fitted with 3-point static, 3-point
retractor safety-belts, approved to UN/ECE Regulation No. 16 or other equivalent
standards.
!!! DO NOT use with 2-points belt.
You can use your child car seat as in Pic 1.
2. How to use the harness buckle - Pic 2
2.1. Guide the two buckle latches together.
2.2. Make sure right side up.
2.3. Engage them before putting them into thehamess buckle,
this should make a
CLICK noise.
2.4. Pull shoulder belts to remove all slack from the lap section
ensuring the harness
lies flat and harness buckle locked. Open the harness buckle by pressing the red
button.
3. Removing 5-point harness - Pic 3,4
3 .1. Loosen the 5-point harness of the child seat as much as possible by press the
button of the crotch bell
3 .2. Tum the baby safety car seat to back, unzip the seat cover.
3 .3. Loosening the shoulder belt in order to access the metal link and connector at the
back of the child seat, remove the belt from connector.then remove the shoulder belt
from metal link .
3 .4. Then from the front of the child seat, pull out shoulder belt through the slots.
3 .5. Pull below both the shoulder pads and the belts to the front through the slots.
(front side of the child seat).
3 .6. Remove the shoulder pads from the shoulder belts and put them in the storage
bag.
3 .7. Roll the shoulder belts separately on both side and place them into the fabric
cover from the slot of fabric.