Juiced Bikes SCORPION 2021, Руководство пользователя

Страница: 19 / 24

31
JBP-SCRP-MANUAL | © 2021 JUICED BIKES
30
JBP-SCRP-MANUAL | © 2021 JUICED BIKES
ERROR CODES
The electronics system has some ability to self-diagnose and
report a limited set of faults. The faults will appear on the
screen as error codes. The chart below explains the meaning of
each error code.
OPERATION MAINTENANCE
BATTERY
NOTICE
Failure to properly charge, store or use the battery will void the warranty.
REMOVING THE BATTERY PACK
You can remove the battery pack from the bike. Remove the
battery pack when storing or transporting the e-bike.
Fig. 29 - Removing Battery Pack
1.
Turn off the bicycle.
2.
Stand on the left side of the bicycle. Locate the keyhole on
the frame near the top of the battery pack.
ADVANCED MATRIX DISPLAY - ERROR CODE CHART
Error
Code
Error Notes
4
Open Throttle
Fault
Throttle has not returned to the start position on start-up. Check to see if the throttle can return to the start position or if there
is something blocking the throttle unit.
5 Throttle Fault Throttle may be damaged. Check the throttle or throttle cable for damage.
6
Low Voltage
Protection
The battery voltage is too low to operate. Incorrect battery was used on the bike. The battery is in sleep mode or not
functioning correctly.
7
Over Voltage
Protection
The battery voltage is too high to operate. Incorrect battery was used on the bike.
Check to be sure that the correct battery is being used on the bike.
8
Motor Hall
Signal Fault
At least one of the motor’s hall sensor wires have been disconnected or damaged.
Disconnect and reconnect the motor cable.
9
Motor Phase
Line Fault
At least one of the motor’s phase wires has been disconnected or damaged.
10
High
Temperature
Fault
The controller has reached the highest allowable temperature.
Allow the controller to cool down before using the e-bike again.
11
Temperature
Sensor Fault
The controller’s temperature sensor has become disconnected or damaged. Contact technical support.
12
Current Sensor
Fault
The controller’s current sensor has become disconnected or damaged. Contact technical support.
21
Speed Sensor
Fault
The speed sensor has become disconnected or damaged. Contact technical support.
30
Communication
Fault
Poor connection between the controller and the display. Check all cable connectors. Check for corrosion damage.
3.
Insert the key into the battery pack lock keyhole.
4.
Turn the key counterclockwise and hold.
5.
Pull the upper portion of the battery pack toward you.
6.
Let go of the key from the battery pack lock.
7.
Pivot the battery pack sideways and lift it away from
the bike.
CHARGING THE BATTERY PACK
The charger can become warm during charging.
!
WARNING
Read and understand all instructions. Failure to follow all
instructions listed below could result in death or serious
personal injury.
•
Use only the charger supplied with the bicycle. Do not
charge the battery pack with any charger that is not
supplied or approved to charge the bike.
•
Do not place anything over the charger while it is charging.
•
Do not use the charger in damp or wet locations.
•
Do not cover the body of the charger when charging.
•
Do not drop the charger or subject it to high vibration. Do
not use a charger that has been dropped.
•
Do not short-circuit the battery pack’s terminals.
5