JUDO PROFIMAT-PLUS
9
Product information
3.
Product information
3.1
Intended purpose
This filter is suitable for use in cold drinking
water up to a water temperature of
maximum 30 °C (86 °F).
ATTENTION
(see chapter “Safety information and
dangers due to non-compliance”)
Please refer to the chapter on “Intended
use” for use restrictions.
This filter removes coarse and fine-grained
particles from the water which are larger
than or equal in size to the mesh size of the
filter.
3.2
Test marks
DIN-DVGW mark
The units conform to the technical regulations
for drinking water installations in accordance
with DIN EN 806 ff. and the national annex
DIN 1988 ff. and DIN EN 1717. They are tes-
ted by the DVGW (Deutsche Vereinigung des
Gas- und Wasserfaches e.V. – technical-sci-
entific association for the gas and water in-
dustries) in accordance with the requirements
of DIN EN 13443-1 for mechanical filters for
the use in drinking water and are entitled to
bear the DIN-DVGW mark.
3.3
Materials used
The materials used are resistant to the
physical, chemical, and corrosive loads to
be expected in the drinking water and fulfil
the requirements specified in DIN EN
13443-1 and DIN 19628 (“Mechanical filters
in drinking water installations”). All materials
are hygienically and physiologically safe.
Plastics fulfil the KTW guideline of the
German Federal Environmental Agency as
well as the DVGW working sheet W 270.
Metallic materials fulfil the requirements of
DIN 50930-6 (Impact on the drinking water
quality).
Particles smaller than the supplied
mesh size and impurities causing
turbidity cannot be filtered out of the
water.
Fig. 3:
Test mark
Содержание PROFIMAT JPF-AT DN 100
Страница 3: ...JUDO PROFIMAT PLUS 3 ...
Страница 34: ...34 JUDO PROFIMAT PLUS Spare parts 10 Spare parts 10 1 JPF A 1 ...
Страница 37: ...JUDO PROFIMAT PLUS 37 Spare parts 10 2 JPF A 1 2 ...
Страница 40: ...40 JUDO PROFIMAT PLUS Spare parts 10 3 JPF A DN 65 100 ...
