JUDO SPEEDY-LongLife
7
Product information
3.
Product information
3.1
Intended purpose
This filter is suitable for use in cold drinking
water up to a maximum ambient tempera-
ture of 86 °F (30 °C).
ATTENTION
(see chapter “Safety information and
dangers due to non-compliance”)
Please refer to the chapter on “Intended
use” for use restrictions.
This filter removes coarse and fine-grained
particles from the water which are larger
than or equal in size to the mesh size of the
filter.
3.2
Materials used
The materials used are resistant to the
physical, chemical, and corrosive loads to
be expected in the drinking water and fulfill
the requirements specified in the DIN EN
13443-1 and DIN 19628 standards
(“Mechanical filters in drinking water instal-
lations”) in Germany. All materials are
hygienically and physiologically safe. Plastics
fulfill the official guidelines of the German
federal environmental agency and the
DVGW work sheet W270. Metallic materials
fulfill the requirements of the German stan-
dard DIN 50930-6 (Impact on the drinking
water quality).
4.
Installation
4.1
General
ATTENTION
(see chapter “Safety information and
dangers due to non-compliance”)
The unit may only be installed by skilled
personnel.
The chapter “Intended use” must always be
observed!
The pipes must be able to support the filter
safely.
Otherwise mechanical damage or fractures/
bursts can occur in the pipes. This can result
in major water damage. People close to the
filter are exposed to a health risk due to the
large quantities of water released. There-
fore, if necessary, the pipes must be addi-
tionally fixed or supported.
A space of at least 200 mm (8 inch) should
be maintained above and below the filter.
These distances are necessary to be able to
properly carry out the backwashing (see
chapter “Backwashing”).
Particles smaller than the supplied
mesh size and impurities causing
turbidity cannot be filtered out of the
water.