Judo 8200367, Инструкция по установке и эксплуатации

Страница: 17 / 32

Operation
JUDO QUICKSOFT MEGA 4 17
large volume of water should be drawn at
another point.
If the desired mixing water hardness is not
achieved, then it can be corrected by turning
the set screw of the mixing valve
within the
marked adjustment range by no more than
a half turn. A value of about 10 °e is recom-
mended.
If necessary, the setting must be changed
and re-measured a number of times until the
desired value is achieved.
After the softening, the sodium concentra-
tion in the mixing water increases, depend-
ent on the raw water hardness and the set
mixing water hardness.
According to current drinking water legisla-
tion, the limit value for sodium in drinking
water is 200 mg/l. Mineral and table water
are not affected by this. Their limit values
are much higher, partially greater than
1000 mg sodium per litre.
If the calculated total sodium content ex-
ceeds the valve permitted by the drinking
water legislation of 200 mg/l, then it can be
corrected by increasing the mixing water
hardness.
The calculation of the sodium content must
then be repeated.
Fig. 11: Adjusting the mixing
Calculation of the sodium content
°e Raw water hardness (ask
the water supply company
or measure with hardness
measuring instrument)
- °e Residual hardness (meas-
ured value)
= °e Difference in water hardness
×
6.4 mg Na
+
/l × °e
Na ions exchange value
= mg/l Increase of the sodium con-
tent by softening
+ mg/l sodium already present in
the raw water (ask the water
supply company)
= mg/l Total sodium content in the
mixing water
Example calculation of the sodium con-
tent
25 °e Raw water hardness
- 10 °e Residual hardness
= 15 °e Difference in water hardness
× 6.4
= 96 mg/l Due to softening:
+ 10 mg/l From the water supply com-
= 106 mg/l In total