Judo 8170238, Дополнение к инструкции по установке и эксплуатации

Страница: 10 / 32

10 JUDO JUKOMAT-LongLife
Installation
4.1.2 Installed position
ATTENTION
(see chapter “Safety information and dan-
gers due to non-compliance”)
Always install the Domestic Water in a verti-
cal position (± 5°)!
Failure to observe this can cause uncon-
trolled backwashing water to escape and
can result in damage caused by water.
4.1.3 Mounting the built-in rotary
flange
Install using the supplied built-in rotary
flange. The built-in rotary flange is used as a
connecting element between the pipe and
the Domestic Water.
It is suitable for both horizontal and vertical
pipes.
The built-in rotary flange must be in-
stalled in the direction of flow. This is
marked by a cast in arrow.
(see Fig. 4)
Failure to comply with this means the Do-
mestic Water cannot work.
ATTENTION
(see chapter “Safety information and dan-
gers due to non-compliance”)
The flange surface of the built-in rotary
flange must be in a vertical position! The
built-in rotary flange must be fitted so that
mechanical stresses cannot occur! Other-
wise mechanical damage can result in the
built-in rotary flange. Otherwise mechanical
damage can result, the pipe may burst or the
built-in rotary flange can break. This can re-
sult in major water damage.
In this case, people close to the Domestic
Water are exposed to a health risk due to
the large quantities of water.
Therefore, during installation, ensure that no
large forces act on the pipe, built-in rotary
flange and Domestic Water.
4.1.4 Mounting the Domestic Water
The built-in rotary flange for the Domestic
Water is supplied with bayonet drill holes.
The necessary seals and screws for this Do-
mestic Water have already been mounted.
Do not unscrew the screws!
– Insert the four flange screws in the bay-
onet drill holes on the built-in rotary
flange (see Fig. 3I).
– Turn the Domestic Water in a clockwise
direction as far as it will go (see Fig. 3II).
– Tighten the four flange screws.
Fig. 3: Built-in rotary flange with Bayonet Fixture
Select the torque (approx. 4 Nm) so
that the gasket closes and the Do-
mestic Water is not damaged or
strained!
I II