Where a high flash point or „no“ flash point liquid formulation will ignite far less readily than a low
flash point liquid and for this reason is strongly advocated.The higher or “no“ flash point formulation
can ignite if the proper conditions exist .These higher or „no“ flash point formulation can ignite if the
proper conditions exist.These conditions are basically two: 1, A sufficiently volume of liquid in the
form of fine particles suspended in the air; and 2. A sufficently high energy source of ignition.
3.
AEROSOL CONCENTRATION.
It has been fully etablished that an acceptable level of
liquid in the atmosphere is one gallon per 50,000 cubic feet (2,7 Liter per 1,000 cubic meters).There
is a safety margin of least 5 to 1 in this figure
4.
AEROSOL IGNITION.
If a combustible atmosphere is established or a combustible
deposit is laid down, a source of ignition may cause a fire. Sources of ignition can be gas or oil pilot
lights or sparks from electrical controls. Therfore, it is strogly recommended that all such sourches
be eliminated by extinguishing all pilot lights and turning off all unnecessary electric power.To avoid
danger of fire or explosion in a enclosed space, the enclosed volume foffing time an required
formulation volume should be carefully calculated.
PROPER AND IMPROPER USE .
The following rules apply to the operation of this machine:
DO
Read the entire manual before operating the machine and pay particular attention to all CAUTIONS
and WARNINGS.
Store formulation in this original labeled container.
Use an extensions cord which is propedy rated for voltage, current and length ans which is free
from nicks, cracks and other signs of prior abuse.For lengths up to 100 feet (30,5 meters) cord NO.
12AWG wire are usually adequate.
Replace damaged ore worn electric cord immediately
Turn the flow valve CLOCKWISE to the OFF position after each spray application while the motor is
still operating to allow clearing of the lines.This will also prevent a siphon effect if the unit is ever
accidentally knocked overwith the valve remaining open.
Always comply with any requirements for protective clothing, goggles, gloves, facial masks or
respirator required by the formulation label.
Ensure that formulations are applied only in strict compliance with the formulation label as well as
local State and Federal regulations.
-4-
Содержание Cold Fog
Страница 1: ...JSR Fogger...
