JSB RS64, Руководство пользователя

Страница: 7 / 16

5
Reset
To reset the system after an Alarm Activation
IMPORTANT NOTE. Reset authorisation depends on the nature of the Alarm
Activation detected by the panel. Some events could indicate that you must contact an
Engineer for advice; the panel records the Alarm Activation in its internal Event Log
and may then enter a Lockout Mode preventing further use until the Engineer has
been consulted.
Enter your 4-Digit Access Code. OPEN light starts flashing.
Press RESET
All lights come on, Warble Tone sounds then the lights go out
System is now reset and ready for re-use.
If system does not reset
Use Remote Reset option (see Remote Communication section(Page 11))
Chime Mode
Chime is used to give a local audible warning from the Guard Zones including Door
Contacts when the system is Unset. This is useful when the premises are occupied
and you wish to be notified if other persons have entered the building. Your
Installation Engineer may have already programmed the system to automatically turn
Chime on during the day. You can also turn Chime On and Off yourself and set which
detectors are to be included in the Chime system.
Chime On
Enter your 4-Digit Access Code. OPEN light starts flashing.
Press CHIME
The FLASHING zones are EXCLUDED from the Chime system
If other chime zones are required, press appropriate numbered keys
System automatically enters chime mode after a short time delay
The OPEN light flashes quickly when Chime Mode is ON
Chime Off
To unset chime mode
Enter your 4-Digit Access Code.
OPEN light flashes slowly
Allow the system to time out.
OPEN light should now be ON continuously.