JSB RS64, Руководство пользователя

Страница: 6 / 16

4
Part Set
Use Part Set when certain zones (e.g. bedrooms) will be occupied. The Part Suite will
automatically omit those Zones which are to be excluded.
Enter your 4-Digit Access Code. OPEN light starts flashing.
Press PART
If system is clear, Part Set tone is heard. This is a soft Clicking sound
Those Zones which are excluded will slowly flash.
Proceed to unset zone via entry/exit route
System is set after the Part Set timer runs out
If system not clear, Fault Tone sounds
Identify which zone light is lit on keypad
Enter your 4-Digit Access Code.
Investigate fault and remedy if possible
If fault cannot be remedied, call engineer
Unset
When you re-enter the protected area you will start the Entry Timer and the Entry
Tone (a slowly broken Exit Tone) will sound. You must then proceed directly to the
nearest Remote Keypad. You will also start the Entry Timer if you use the Remote
Keypad when the system is Set.
Whenever you hear the Entry Tone:
Enter your 4-Digit Access Code.
Entry Tone stops
The system should now be Unset with the OPEN LIGHT ON.
If zone and fault lights are lit, there has been an activation
You will now need to Reset the system (see opposite)
To silence an Alarm
It is quite possible for an alarm activation to occur while you are on the premises.
The Alarm Tones are:
Fire Alternating 2-tone sound.
Intruder Wailing sound.
Tamper Loud Rapid Pips (Fault Tone)
Enter your 4-Digit Access Code.
Alarm should be silenced
The Remote Keypad lights will indicate what has happened
You will now need to Reset the system (see opposite)