JRC JSS-2150 -, Инструкция по эксплуатации

Страница: 101 / 248

Operation
4-35
4.3.10 Reducing the Tx power
■
Procedure
■
1
11
.
..
Press the
MENU
key, and through
hierarchical menus, select 5.5 Transmitter.
2
22
.
..
Select 1. Power and press ENT to move the
cursor to the right, then use the jog dial to
Medium
* 1 or select Low.
After selecting and pressing ENT, the settings are
complete.
*1: Medium is selectable only for JSS-2250/2500.
- The same settings can be done by pressing and holding the FUNC key and the
9
key at the same time.
-
When the Tx power is reduced, M or L is displayed on the screen.
4.3.11 Setting the antenna tuning power
■
Procedure
■
On the 5.5 Transmitter menu mentioned above, select the 2. Tune power and press ENT
to move the cursor to the right, then select a value from 0 to 3 with the jog dial.
 The antenna tune output grows larger by about 5W step.
 The factory default setting is 0 (Normal).
 After selecting and pressing ENT, the settings are complete.
4.3.12 Setting the Auto Tune Start (ATS) function
■
Procedure
■
On the 5.5 Transmitter menu mentioned above, select the 3. Auto tune start and press
ENT to move the cursor to the right, then set to ON or OFF with the jog dial.
 After setting to ON, when pressing the PTT key under the following condition in TEL mode,
the antenna tuner starts tuning automatically.
- When the Tx frequency is untuned, or
- when the PA power is not turned on, i.e. the ON is not displayed.
 This ATS setting data is saved in the controller. Therefore if two controllers are connected,
this function can be set to the controllers respectively.
Note
P W R
RDC
5.5)Transmitter
1.Power :High
2.Tune power :Normal
3.Auto tune start :ON
0.Back
5.5)Transmitter
1.Power : Low
2.Tune power :Normal
3.Auto tune start :ON
0.Back