JRC JMA-1030 Series, Инструкция по эксплуатации

Страница: 106 / 198

Chapter 5 VARIOUS FUNCTION ICONS
72
5.12.6 VIDEO NOISE REJECTION
This function rejects signals that assumed as noise and clutter in radar videos.
OFF: Turns off the noise rejection function, and displays all signals. Targets are popped up from noise and
displayed like analog signals.
Level1: Rejects the signals of definitely unwanted waves (noise and clutter). When detection of targets or
unwanted waves in no definite, the signals are displayed. When detection of targets is definite, the
signals are displayed.
Level2: Rejects the signals of definitely unwanted waves (noise and clutter). When detection of targets or
unwanted waves in no definite, the signals are displayed. When detection of targets is definite, the
signals are displayed. It will remove the signal that can be regarded as unnecessary wave of more
than level 1.
Level3: Select if “Level1” and “Level2” cannot reject the signals enough.
5.12.7 TIMED TX
This function repeats the TX and Non-TX which set by the initial setting menu.
The rotating of antenna does not stop during the Non-TX.
To enable the timed TX function, you need to set ON Timed TX in this menu after you set ON of Adaptation in
initial setting menu (refer to 8.3.5).
OFF: Sets the timed TX function to OFF. ON: Sets the timed TX function to ON.
The state mark of Timed TX appears. (Below of left side of display)
Note:
If you execute function of the timed TX, please be careful.
Because if you forget to execute the timed TX, you will misunderstand that radar transmitting was stopped
and radar echo disappeared in the transmitting. You must be remembered that you had set on function of
Timed TX. Please use timed TX with caution fully.