JRC JHS-770S -, Инструкция по эксплуатации

Страница: 72 / 162

Operation
4-28
9
9
9
.
.
.
The call will be completed after displayed
the working channel as shown at right.
Start communications using the handset.
¾ The example at right shows when proposed
CH16 as a working channel.
¾
When completed the communications,
return the handset to the cradle.
If the called station is unable to comply with the call, as with routine calls, own station
(caller) may receive a negative acknowledgement mentioned above section. In this
case, if possible according to the message, wait and retry the calling again later.
4.4.1.3 Other features of the safety call (Position request/ Test)
Additional features of safety call, such as a ship position request call or a DSC test call are available.
In these cases, there is no voice communication and not needed to set a working channel.
However, the procedures are otherwise identical to those mentioned above, so describes below after
completed the editing steps.
(1) Position request call
■
Procedure
■
1
1
1
.
.
.
After inputting the ship's address and type
(Position RQ), the sending confirmation
screen will appear.
2
2
2
.
.
.
Press ENT to transmit the call.
After completed the transmission, the popup
screen shown at right will be displayed to wait
the acknowledgement.
If received no response for 5 minutes,
the screen will return to the editing
screen.
Note
2.1.2)Specific station
Address :123456789
Type :Position RQ
[Call] [Cancel]
2.1.2)Specific station
Address :123456789
Work CH :71
[Call] [Cancel]
Waiting for
Acknowledgement.
[CANCEL]
Note
Station1 TIME 23:59(UTC)
POS 89ﾟ59'S
EXT 179ﾟ59'W
16
CH
SQL
CH70
CH
SW
[ITU]