P.40
0%
100%
0%
100%
50%
80%
3 .【Throttle curve (Transmitter Throttle Curve Function)】
Adjust the throttle curve so the rotor rpm is as per the table on page 33
For details, please refer to your transmitter Instruction Manual and adjust the values accordingly.
Please be extra careful not to turn on the motor.
The throttle values here are just examples. In order to prevent over-speed of the main rotor, please adjust carefully after
test flying the helicopter.
※ If your radio has a Throttle delay function, we recommend you to use this to prevent sudden changes in rotor speed
when changing flight modes.
Throttle curve
Low
Low
Stick position
Stick position
Power output
Power output
【Hovering】
【Stunt / 3D】
High
High
Although some items can only be adjusted after test flights, it is possible to do some final check prior to flight. Please
recheck the following:
① Look through all the steps in the Instruction Manual again and make sure that all bolts are firmly tightened. Check in
particular the bolts used for mounting the balls to the levers, and each bolt which was tightened after backlash adjustment
of the gear mesh was completed.
② Confirm all servos function smoothly and their direction of operation is correct.
Also check that the servo horn screws are firmly tightened.
③ Make sure the gyro control direction is correct.
④ Make sure that the battery in the transmitter and that powering the receiver (in the helicopter) is fully charged.
⑤ Check that the receiver, gyro, ESC and battery are firmly secured.
⑥ Make sure that the Main Rotor Blades and the Tail Rotor Blades are attached in the correct orientation.
If no issues have been found after checking all of the above, test fly the helicopter and make adjustments as necessary.
If possible, the helicopter should be test flown under the guidance of an experienced operator.
FINAL CHEKS PRIOR TO FLIGHT
